enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Head tube - Wikipedia

   en.wikipedia.org/wiki/Head_tube

   The steering axis angle, also called caster angle, is the angle that the head tube and hence the steering axis makes with the horizontal or vertical, depending on convention. The steering axis is the axis about which the steering mechanism (fork, handlebars, front wheel, etc.) pivots.

3. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than ⁠ 1 / 4 ⁠ inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.

4. Stem (bicycle part) - Wikipedia

   en.wikipedia.org/wiki/Stem_(bicycle_part)

   Quill stem classic single-piece type Threadless stem shown with cable hole. The stem is the component on a bicycle that connects the handlebars to the steerer tube of the bicycle fork. Sometimes called a goose neck, [1] a stem's design belongs to either a quill or threadless system, and each system is compatible with respective headset and fork ...

5. Trapezoidal thread form - Wikipedia

   en.wikipedia.org/wiki/Trapezoidal_thread_form

   The actual thread heights on both the internal (nut) and external (bolt) threads differ from ⁠ P / 2 ⁠ by allowances (or clearances): A minimum root-crest clearance of 0.01 in (0.25 mm) (diametral) between opposing threads with 10 tpi (threads-per-inch) or fewer, and 0.005 in (0.13 mm) for finer pitches.

6. Barrel threads - Wikipedia

   en.wikipedia.org/wiki/Barrel_threads

   Typically, many rifles use thread diameters in the range between 25–27 mm (0.98–1.06 in). [ citation needed ] Many older rifles from the first half of the 20th century use a thread pitch around 2 mm (12.7 TPI), while many modern rifle use thread pitches around 1.5 mm (16.93 TPI).

7. Screw thread - Wikipedia

   en.wikipedia.org/wiki/Screw_thread

   Similarly, M10 (10 mm nominal outer diameter) as per ISO 261 has a coarse thread version at 1.5 mm pitch and a fine thread version at 1.25 mm pitch. The term coarse here does not mean lower quality, nor does the term fine imply higher quality. The terms when used in reference to screw thread pitch have nothing to do with the tolerances used ...