Search results
Results from the WOW.Com Content Network
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
Pipe sizes are documented by a number of standards, including API 5L, ANSI/ASME B36.10M (Table 1) in the US, and BS 1600 and BS 1387 in the United Kingdom. Typically the pipe wall thickness is the controlled variable, and the Inside Diameter (I.D.) is allowed to vary. The pipe wall thickness has a variance of approximately 12.5 percent.
This is +10% for PD 5500, and ASME Section VIII div 1 & 2 (with an additional +10% allowance in ASME Section VIII for a fire relief case). ASME has different criteria for steam boilers. Maximum expected operating pressure (MEOP) is the highest expected operating pressure, which is synonymous with maximum operating pressure (MOP). [3]
Process piping and power piping are typically checked by pipe stress engineers to verify that the routing, nozzle loads, hangers, and supports are properly placed and selected such that allowable pipe stress is not exceeded under different loads such as sustained loads, operating loads, pressure testing loads, etc., as stipulated by the ASME B31, EN 13480, GOST 32388, RD 10-249 or any other ...
For example, in 100 countries the ASME BPVCcode stipulates the requirements for design and testing of pressure vessels. [4] The formula is also common in the pipeline industry to verify that pipe used for gathering, transmission, and distribution lines can safely withstand operating pressures.
Standard dimension ratio (SDR) is a method of rating a pipe's durability against pressure. The standard dimension ratio describes the correlation between the pipe dimension and the thickness of the pipe wall. [1] Common nominations are SDR11, SDR17, SDR26 and SDR35. Pipes with a lower SDR can withstand higher pressures.
ASME B36.19M: Stainless-steel pipe; ASME B31.3 2008: Process piping ... high compressive force. [30] ... are sensitive to residual and thickness stresses caused by ...
The requirements specified within various pressure vessels and piping codes are mostly due to the chemical makeup and thickness of the material. [1] Codes such as ASME Section VIII and ASME B31.3 will require that a specified material be post weld heat treated if it is over a given thickness. [1] Codes also require PWHT based solely on the ...