Search results
Results from the WOW.Com Content Network
Electrical cord for powering a block heater. A block heater is used in cold climates to warm an engine prior to starting. They are mostly used for car engines; however, they have also been used in aircraft engines. The most common design of block heater is an electrical heating element embedded in the engine block.
D2 switches off and D3 switches on, charging C3 to 3V in and so on with charge passing up the chain, hence the name charge pump. The final diode-capacitor cell in the cascade is connected to ground rather than a clock phase and hence is not a multiplier; it is a peak detector which merely provides smoothing .
Fig. 1: Schematic of a flyback converter. The flyback converter is used in both AC/DC, and DC/DC conversion with galvanic isolation between the input and any outputs. The flyback converter is a buck-boost converter with the inductor split to form a transformer, so that the voltage ratios are multiplied with an additional advantage of isolation.
The oscillator circuit is responsible for creating the elevated frequency electric current, which when applied to the work coil creates the magnetic field which heats the part. The basic elements of the circuit are an inductance (tank coil) and a capacitance (tank capacitor) and an oscillator valve. Basic electrical principles dictate that if a ...
One classic use for a chopper circuit and where the term is still in use is in chopper amplifiers. These are DC amplifiers. Some types of signals that need amplifying can be so small that an incredibly high gain is required, but very high gain DC amplifiers are much harder to build with low offset and 1 / f {\displaystyle 1/f} noise, and ...
An optimized heater design helps to control the heating power and modulate the local temperatures across the heater substrate. In cases where there is a requirement of two or more heating zones with different power densities over a relatively small area, a thick-film heater can be designed to achieve a zonal heating pattern on a single substrate.
A water heater that maintains desired temperature by turning the applied power on and off (as opposed to continuously varying electrical voltage or current) based on temperature feedback is an example application of bang–bang control. Although the applied power switches from one discrete state to another, the water temperature will remain ...
The heat dissipation in integrated circuits problem has gained an increasing interest in recent years due to the miniaturization of semiconductor devices. The temperature increase becomes relevant for cases of relatively small-cross-sections wires, because such temperature increase may affect the normal behavior of semiconductor devices.