Ad
related to: immersion cooling vs liquid freezer fan
Search results
Results from the WOW.Com Content Network
Immersion cooling is an IT cooling practice by which complete servers are immersed in a dielectric, electrically non-conductive fluid that has significantly higher thermal conductivity than air. Heat is removed from a system by putting the coolant in direct contact with hot components, and circulating the heated liquid through heat exchangers.
Computer cooling. A finned air cooled heatsink with fan clipped onto a CPU, with a smaller passive heatsink without fan in the background. A 3-fan heatsink mounted on a video card to maximize cooling efficiency of the GPU and surrounding components. Commodore 128DCR computer's switch-mode power supply, with a user-installed 60 mm cooling fan.
Liquid cooling is also used to remove heat from large buildings by using chillers which transfer the coolant from the evaporator to air handling units, chilled beams and fan coil units inside the building, and to the cooling towers from the condenser if the condenser is liquid-cooled.
Active cooling is a heat-reducing mechanism that is typically implemented in electronic devices and indoor buildings to ensure proper heat transfer and circulation from within. Unlike its counterpart passive cooling, active cooling is entirely dependent on energy consumption in order to operate. It uses various mechanical systems that consume ...
This term describes device cooling by the convection currents of the warm air being allowed to escape the confines of the component to be replaced by cooler air. Since warm air normally rises, this method usually requires venting at the top or sides of the casing to be effective.
Alternatively, a liquid-to-liquid or similar heat exchanger may be used instead. The high-temperature system transfers heat to a conventional condenser that carries the entire heat output of the system and may be passive, fan, or water-cooled. This is an auto-cascade process with two different refrigerants.
Liquid nitrogen has a boiling point of about −196 °C (−321 °F; 77 K). It is produced industrially by fractional distillation of liquid air. It is a colorless, mobile liquid whose viscosity is about one-tenth that of acetone (i.e. roughly one-thirtieth that of water at room temperature). Liquid nitrogen is widely used as a coolant.
The Freezer is the name of the CPU coolers from Arctic GmbH, which has been the company's staple product for many years. [1] To most enthusiasts, Arctic is best known for their Freezer line of CPU coolers as well as their thermal compound called MX-2 and MX-4. [2] The Freezer line of coolers is available in different fan speed, cooling capacity ...
Ad
related to: immersion cooling vs liquid freezer fan