Search results
Results from the WOW.Com Content Network
A flexible impeller pump is a positive-displacement pump that, by deforming impeller vanes, draws the liquid into the pump housing and moves it to the discharge port with a constant flow rate. The flexibility of the vanes enables a tight seal to the internal housing, making the pump self-priming , while also permitting bi-directional operation.
The simplest inlet to a centrifugal compressor is typically a simple pipe. Depending upon its use/application inlets can be very complex. They may include other components such as an inlet throttle valve, a shrouded port, an annular duct (see Figure 1.1), a bifurcated duct, stationary guide vanes/airfoils used to straight or swirl flow (see Figure 1.1), movable guide vanes (used to vary pre ...
In self-priming centrifugal pumps with a separation chamber the fluid pumped and the entrained air bubbles are pumped into the separation chamber by the impeller action. The air escapes through the pump discharge nozzle whilst the fluid drops back down and is once more entrained by the impeller. The suction line is thus continuously evacuated.
In a top load washing machine the agitator projects from the bottom of the wash basket and creates the wash action by rotating back and forth, rolling garments from the top of the load, down to the bottom, then back up again. There are several types of agitators with the most common being the "straight-vane" and "dual-action" agitators.
The vanes do not have a wall, making open impellers slightly weaker than closed or semi-closed impellers. However, as the side plate is not fixed to the inlet side of the vane, the blade stresses are significantly lower. [4] In pumps, the fluid enters the impeller's eye, where vanes add energy and direct it to the nozzle discharge.
A fluid flow conditioning device, the cheng rotation vane (CRV) is a stationary vane [1] fabricated within a pipe piece as a single unit and welded directly upstream of an elbow before the pump inlet, flow meters, compressors, or other downstream equipment.
Each stage is a stationary ring of nozzle guide vanes followed by spinning blades. The gas is moving from left to right and the 2nd and 3rd vane rings have been removed to better show the blades. The first ring shows the shape of the vanes and how they turn the gas from the combustor into a tangential direction necessary to spin the bladed disc.
Figure 1: Components of a centrifugal fan An external motor belt driven inline centrifugal fan discharging inline to the exterior of a building through a duct. Unlike non-inline/non-concentric impeller casing design with a cutoff blade above, the concentrically symetric cylinder casing and impeller geometry of inline type redirects the outflow around so that it is parallel to the inflow of gases.