Search results
Results from the WOW.Com Content Network
The measured depth is the length of the well including any angled or horizontal sections. Consider two wells, X and Y. Well X has a measured depth of 9,800 ft and a true vertical depth of 9,800 ft while well Y has measured depth of 10,380 ft while its true vertical depth is 9,800 ft.
The purpose of surface casing is to isolate freshwater zones so that they are not contaminated during drilling and completion. Surface casing is the most strictly regulated due to these environmental concerns, which can include regulation of casing depth and cement quality. A typical size of surface casing is 13 + 3 ⁄ 8 inches (340 mm). [5]
As technology has advanced, more modern drillers have better control of the overall well. Oil well control is the management of the dangerous effects caused by the unexpected release of formation fluid, such as natural gas and/or crude oil, upon surface equipment of oil or gas drilling rigs and escaping into the atmosphere.
Well depth values from the wireline loggers operation are referred to as "logger's depth". The loggers depth are typically considered more reliable than the drillers depth. The differences between loggers and drillers depths are due to different stretch in the drilling string when drilling, and the wire line entered into the bore hole during ...
The tubing may also have flow control mechanism. Single-well concentric kill string: within the well a small diameter concentric kill string is used to circulate kill fluids when needed. Single-well 2-tubing completion: in this instance 2 tubing strings are inserted down 1 well. They are connected at the lower end by a circulating head.
Conductor Casing. In the offshore drilling industry, the conductor pipe is set in the seabed, and is a key structural foundation for the subsea wellhead. When drilling an offshore well, a marine riser is connected to the well, and this is subjected to large environmental forces such as current and waves which are transferred to the conductor ...
Production casing is the final casing string set in a well and usually reaches from the surface to Target Depth (TD). The type of casing used depends upon the different conditions in the well. Commonly, production casing sizes range from 4 + 1 ⁄ 2 in (110 mm) to as large as 9 + 5 ⁄ 8 in (240 mm). It is the last string cemented in a well ...
Designing well programs (e.g., casing sizes and setting depths) to prevent blowouts (uncontrolled well-fluid release) while allowing adequate formation evaluation Designing or contributing to the design of casing strings and cementing plans, directional drilling plans, drilling fluids programs, and drill string and drill bit programs