enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Diagonal pliers - Wikipedia

   en.wikipedia.org/wiki/Diagonal_pliers

   Instead of using a shearing action as with scissors, diagonal pliers cut by indenting and wedging the wire apart.The jaw edges are ground to a symmetrical "V" shape, thus the two jaws can be visualized to form the letter "X", as seen end-on when closed.

3. Woodturning - Wikipedia

   en.wikipedia.org/wiki/Woodturning

   This sharpening process requires either skill of the craftsman, or one of the many available sharpening jigs, which facilitate maintaining a specific bevel on the tool. As with any mechanical sharpening method, overheating or blueing is a danger to be avoided as it will ruin the steel's temper, rendering the steel too soft to maintain a sharp edge.

4. Chisel - Wikipedia

   en.wikipedia.org/wiki/Chisel

   A sharp wood chisel in combination with a forstner wood drill bit is used to form this mortise for a half-lap joint in a timber frame. Parts of a wood chisel. Woodworking chisels range from small hand tools for tiny details, to large chisels used to remove big sections of wood, in 'roughing out' the shape of a pattern or design.

5. Woodworking - Wikipedia

   en.wikipedia.org/wiki/Woodworking

   Chisels Five woodworking wood chisels: Chisels are tools with a long blade, a cutting edge, and a handle. Used for cutting and shaping wood or other materials. [20] Claw hammer A common hammer, the claw hammer, used in woodworking and other activities

6. Nibbler - Wikipedia

   en.wikipedia.org/wiki/Nibbler

   Manual nibbler, punch-and-die type. A nibbler, or nibblers, [1] is a tool for cutting sheet metal with minimal distortion. They may be used for nibbling.One type operates much like a punch and die, with a blade that moves in a linear fashion against a fixed die, removing small bits of metal and leaving a kerf approximately 6 mm (0.24 in) wide.

7. Jig (tool) - Wikipedia

   en.wikipedia.org/wiki/Jig_(tool)

   An example of a jig is when a key is duplicated; the original is used as a jig so the new key can have the same path as the old one. Since the advent of automation and computer numerical controlled (CNC) machines, jigs are often not required because the tool path is digitally programmed and stored in memory. Jigs may be made for reforming plastics.