Search results
Results from the WOW.Com Content Network
There are several classes of microphone placement for recording and amplification. In close miking, a microphone is placed relatively close to an instrument or sound source, within three to twelve inches, producing a dry or non-reverberant sound. [1]
The placement can be done with three separate microphone stands or using one or more bars. In contrast to the ORTF stereo technique , the Decca Tree size is not fixed and may vary considerably; distances between the two back microphones are seen between 0.6 and 1.2 m; the front microphone is set proportionally and can be mounted slightly lower ...
The boundary microphone can be used as a piano mic by placing it inside the piano lid, an approach which can obtain better pickup of the piano's mix of sharp percussive transients and gentle undertones than other microphone options. Boundary mics are used on hockey boards for body check sound effects. They are also commonly used to record full ...
ORTF setup. The ORTF stereo technique, also known as side-other-side, is a microphone technique used to record stereo sound.It was devised around 1960 at the now-defunct Office de Radiodiffusion Télévision Française (ORTF).
The principal responsibility of the boom operator is microphone placement, usually using a boom pole (or "fishpole") with a microphone attached to the end (called a boom mic), their aim being to hold the microphone as close to the actors or action as possible without allowing the microphone or boom pole to enter the camera's frame. [1]
Two bi-directional AKG C414 microphones set up in a Blumlein pair. Blumlein pair is a stereo recording technique invented by Alan Blumlein for the creation of recordings that, upon replaying through headphones or loudspeakers, recreate the spatial characteristics of the recorded signal.
The internal electronic circuitry of an active noise-canceling mic attempts to subtract noise signal from the primary microphone. The circuit may employ passive or active noise canceling techniques to filter out the noise, producing an output signal that has a lower noise floor and a higher signal-to-noise ratio .
This can be particularly useful when placing microphones on a drum stand when the microphone stands must compete for space with things like cymbal stands. Boom arms are offered both in fixed length and adjustable (telescoping) lengths. Another handy device for adjusting microphone placement is a flexible goose neck tube. Made of a spiral-wound ...