enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. FASTON terminal - Wikipedia

   en.wikipedia.org/wiki/FASTON_terminal

   There are free-hanging wire and circuit board mounted versions of both tabs and receptacles. All widths come mostly in one of two tab thicknesses: 0.032 and 0.020 in (0.8 and 0.5 mm). All widths come mostly in one of two tab thicknesses: 0.032 and 0.020 in (0.8 and 0.5 mm).

3. Cable tray - Wikipedia

   en.wikipedia.org/wiki/Cable_tray

   Lighter cable trays are more appropriate in situations where a great number of small cables are used, such as for telephone or computer network cables. These trays may be made of wire mesh, called "cable basket", [2] or be designed in the form of a single central spine (rail) with ribs to support the cable on either side.

4. NEMA connector - Wikipedia

   en.wikipedia.org/wiki/NEMA_connector

   All NEMA 1 devices are two-wire non-grounding devices (hot-neutral) rated for 125 V maximum. 1-15P plugs have two parallel flat blades, 1 ⁄ 4 inch (6.4 mm) wide, 0.06 inches (1.5 mm) thick, 5 ⁄ 8 – 23 ⁄ 32 inch (15.9–18.3 mm) long, and spaced 1 ⁄ 2 inch (12.7 mm) apart. 1-15R receptacles have been prohibited in new construction in ...

5. EIA RF Connectors - Wikipedia

   en.wikipedia.org/wiki/EIA_RF_Connectors

   EIA RF Connectors are used to connect two items of high power radio ... Sizes covered under these two standards range from 3/8 to 6 1/8 inch outside diameter (OD) for ...

6. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   PCB mount connectors soldered to a printed circuit board, providing a point for cable or wire attachment. [6]: 56 (e.g. pin headers, screw terminals, board-to-board connectors) Splice or butt connectors (primarily insulation displacement connectors) that permanently join two lengths of wire or cable

7. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.