Search results
Results from the WOW.Com Content Network
In computer networking, the Point-to-Point Protocol over ATM (PPPoA) is a layer 2 data-link protocol typically used to connect domestic broadband modems to ISPs via phone lines. It is used mainly with DOCSIS and DSL carriers, by encapsulating PPP frames in ATM AAL5. Point-to-Point Protocol over Asynchronous Transfer Mode (PPPoA) is specified by ...
RFC 2364 describes Point-to-Point Protocol over ATM (PPPoA) as a method for transmitting PPP over ATM Adaptation Layer 5 , which is also a common alternative to PPPoE used with DSL. PPP, PPPoE and PPPoA are widely used in WAN lines. PPP is a layered protocol that has three components: [4]
The Point-to-Point Protocol over Ethernet (PPPoE) is a network protocol for encapsulating Point-to-Point Protocol (PPP) frames inside Ethernet frames. It appeared in 1999, in the context of the boom of DSL as the solution for tunneling packets over the DSL connection to the ISP's IP network, and from there to the rest of the Internet.
While it has initially been used to manage only dial-up access, it is also used to manage broadband connections such as DSL, if Point-to-Point Protocol over Ethernet (PPPoE) or Point-to-Point Protocol over ATM (PPPoA) is used. The role of pppd is managing PPP session establishment and session termination.
Nearly all IP over Ethernet implementations use the Ethernet II frame format. Ethernet with LLC and SNAP: 1492 [8] Ethernet jumbo frames: 1501–9202 [9] or more [10] The limit varies by vendor. For correct interoperation, frames should be no larger than the maximum frame size supported by any device on the network segment. [11] PPPoE v2: 1492 [12]
ATM point-to-point connections (virtual circuits), on the other hand, are bidirectional, allowing data to flow in both directions over the same path. [f] Both ATM and MPLS support tunneling of connections inside connections. MPLS uses label stacking to accomplish this while ATM uses virtual paths. MPLS can stack multiple labels to form tunnels ...
This AAL assumes that the data is sequential from the end user and uses the Payload Type Indicator (PTI) bit to indicate the last cell in a transmission. Examples of services that use AAL 5 are classic IP over ATM, Ethernet Over ATM, SMDS, and LAN Emulation (LANE). AAL 5 is a widely used ATM adaptation layer protocol.
Among its early design documents, the Forum created TR-001 (1996) system reference model, which together with later TR-012 (1999) core network architecture, recommended PPP over an ATM transport layer as the best practice for a DSL ISP. This was subsequently refined in TR-025 and TR-059.