Search results
Results from the WOW.Com Content Network
A pedestal sump pump with a float switch. A float switch is a type of level sensor, a device used to detect the level of liquid within a tank. The switch may be used to control a pump, as an indicator, an alarm, or to control other devices. One type of float switch uses a mercury switch inside a hinged float.
A French drain, PVC pipe, or other drainage system is installed in the newly made channel. The installed drain is covered with new cement. The installed drain is covered with new cement. The drainage system collects any water entering the basement and drains it to an internally placed sump pump system, which will then pump the water out of the ...
Sump pumps are used where basement flooding may otherwise happen, and to solve dampness where the water table is near or above the foundation of a structure. Sump pumps send water away from a location to any place where it is no longer problematic, such as a municipal storm drain, a dry well, or simply an open-air site downhill from the building (sometimes called "pumping to daylight").
In the U.S., every plumbing fixture must also be coupled to the system's vent piping. [1] Without a vent, negative pressure can slow the flow of water leaving the system, resulting in clogs, or cause siphonage to empty a trap. The high point of the vent system (the top of its "soil stack") must be open to the exterior at atmospheric pressure.
A pump for household use is usually 1 hp, 1.5 hp or 2 hp. A cutting mechanism macerates waste and grinds items that are not normally found in sewage, but may get flushed down the toilet. The pump has a level sensor either built into the pump, called “sensing bells,” or attached externally to the pump, typically a float switch. (The level ...
Because certain combinations of check valve failure and/or system backpressure cause the relief valve to discharge, the device must be mounted in a location where the drain will not become flooded. An example of where backflow would harm the water supply is the use of well washing devices inside underground sewerage pumping stations.
Pumps being used to dewater a spillway at Baldhill Dam. Dewatering / d iː ˈ w ɔː t ər ɪ ŋ / is the removal of water from a location. This may be done by wet classification, centrifugation, filtration, or similar solid-liquid separation processes, such as removal of residual liquid from a filter cake by a filter press as part of various industrial processes.
The soils cannot drain pore water fast enough in a repeated compression causing the pore water pressure to be accumulated to a high pressure. This causes the soils to lose their stress and become muddy. Any objects with apparent weights of less than of those of the ground's muddy water will float up. Manholes, which are sealed hollowed objects ...