Search results
Results from the WOW.Com Content Network
4 in × 1 in × 5.75 in (101.6 mm × 25.4 mm × 146 mm) = 376.77344 cm³. This smaller form factor is similar to that used in an HDD by Rodime in 1983, which was the same size as the "half height" 3½" FDD, i.e., 1.63 inches high. Today, the 1-inch high ("1/3 height," "slimline," or "low-profile") version of this form factor is the most popular ...
Full-height bays were found in old PCs in the early to mid-1980s. They were 3 + 1 ⁄ 4 inches (82.6 mm) high, 5 + 3 ⁄ 4 inches (146.1 mm) wide, and up to 8 inches (203.2 mm) deep, used mainly for hard disk drives and floppy disk drives. This is the size of the internal (screwed) part of the bay, as the front side is actually 5 + 7 ⁄ 8 ...
Tablet cases sizes Tablet PC Height Width Depth Screen Case size Acer Iconia Tab A500 [1]: 10.2 in (260 mm) 7 in (180 mm) 0.52 in (13 mm) 10.1 in (260 mm)
95 × 120 mm (3.7 × 4.7 in) Used in embedded systems. Requires a carrier board. Typically used for COM-HPC Client Type modules. COM-HPC Size B PICMG: 2020 120 × 120 mm (4.7 × 4.7 in) Used in embedded systems. Requires a carrier board. Typically used for COM-HPC Client Type modules. COM-HPC Size C PICMG: 2020 160 × 120 mm (6.3 × 4.7 in)
Rack with sample component sizes including an A/V half-rack unit. A rack unit (abbreviated U or RU) is a unit of measure defined as 1 + 3 ⁄ 4 inches (44.45 mm). [1] [2] It is most frequently used as a measurement of the overall height of 19-inch and 23-inch rack frames, as well as the height of equipment that mounts in these frames, whereby the height of the frame or equipment is expressed ...
This list of computer size categories attempts to list commonly used categories of computer by the physical size of the device and its chassis or case, in descending order of size. One generation's "supercomputer" is the next generation's "mainframe", and a "PDA" does not have the same set of functions as a "laptop", but the list still has ...
Common screen dimensions are listed in the table below (the most common diagonal dimensions in inches as of 2020 are bolded). If the display is not listed, then the following equations can be used. Note that D is the diagonal (in centimeters or inches), W is the width (in pixels), and H is the height (in pixels).
A single card is 100 mm high. Taller cards add a 133.35 mm, so that a double height card is 233.35 mm high and a triple 366.7 mm high. Enclosure heights are multiples of 3U, with the cards always 33.35 mm (1.313 in) shorter than the enclosure. Two common heights are 3U (a 100 mm card in a 5.25 in (133.35 mm) subrack) and 6U (a 233.35 mm card in ...