Search results
Results from the WOW.Com Content Network
Installation of a hydrodynamic separator along an Arizona highway. In civil engineering (specifically hydraulic engineering), a hydrodynamic separator (HDS), also called a swirl separator, is a stormwater management device that uses cyclonic separation to control water pollution.
The vortex tube, also known as the Ranque-Hilsch vortex tube, is a mechanical device that separates a compressed gas into hot and cold streams. The gas emerging from the hot end can reach temperatures of 200 °C (390 °F), and the gas emerging from the cold end can reach −50 °C (−60 °F). [ 1 ]
Multiple-cyclone separators consist of a number of small-diameter cyclones, operating in parallel and having a common gas inlet and outlet, as shown in the figure, and operate on the same principle as single cyclone separators—creating an outer downward vortex and an ascending inner vortex. Multiple-cyclone separators remove more dust than ...
Spiral separators of the wet type, also called spiral concentrators, are devices to separate solid components in a slurry, based upon a combination of the solid particle density as well as the particle's hydrodynamic properties (e.g. drag).
Multiple-cyclone separators consist of a number of small-diameter cyclones, operating in parallel and having a common gas inlet and outlet, as shown in the figure, and operate on the same principle as single cyclone separators—creating an outer downward vortex and an ascending inner vortex. Multiple-cyclone separators remove more dust than ...
The tube tapers to a small exit aperture at one or both ends. This tangential injection of gas results in a spiral or vortex motion within the tube, and two gas streams are withdrawn at opposite ends of the vortex tube; centrifugal force providing the isotopic separation. The spiral swirling flow decays downstream of the feed inlet due to ...
A vortex breaker is a device used in engineering to stop the formation of a vortex when a fluid (liquid or gas) is drained from a vessel such as a tank or vapor–liquid separator. The formation of vortices can entrain vapor in the liquid stream, leading to poor separation in process steps such as distillation or excessive pressure drop, [ 1 ...
In a centrifugal oil and water separator, the force of gravity is one-thousand [citation needed] times greater that of the coalescing plate pack separator or the petrol interceptor, so the separation is much greater. Not only is the force of separation greater, but there are fewer working parts so maintenance is much easier and cheaper.