Search results
Results from the WOW.Com Content Network
For example, the answer to 7×2=14 is found by first positioning the top scale to start above the 2 of the bottom scale, and then reading the marking 1.4 off the bottom two-decade scale where 7 is on the top scale: But since the 7 is above the second set of numbers that number must be multiplied by 10. Thus, even though the answer directly ...
A slide rule consists of a body [note 1] and a slider that can be slid along within the body and both of these have numerical scales inscribed on them. On duplex rules the body and/or the slider have scales on the back as well as the front. [2] The slider's scales may be visible from the back or the slider may need to be slid right out and ...
A modern scientific calculator with an LCD. An electronic calculator is typically a portable electronic device used to perform calculations, ranging from basic arithmetic to complex mathematics. The first solid-state electronic calculator was created in the early 1960s. Pocket-sized devices became available in the 1970s, especially after the ...
Scale ruler. A scale ruler is a tool for measuring lengths and transferring measurements at a fixed ratio of length; two common examples are an architect's scale and engineer's scale. In scientific and engineering terminology, a device to measure linear distance and create proportional linear measurements is called a scale.
The 1/4-turn shaft carries (also, each column) gears with 12, 16, and 20 teeth, for 3, 4, and 5. Digits [1] and [2] are handled by 12 and 24-tooth gears on the 1/12-revolution shaft. Practical design places the 12th-rev. shaft more distant, so the 1/4-turn shaft carries freely-rotating 24 and 12-tooth idler gears.
A scale or balance is a device used to measure weight or mass. These are also known as mass scales, weight scales, mass balances, massometers, and weight balances. The traditional scale consists of two plates or bowls suspended at equal distances from a fulcrum. One plate holds an object of unknown mass (or weight), while objects of known mass ...
Various scales may be used for different drawings in a set. For example, a floor plan may be drawn at 1:50 (1:48 or 1 ⁄ 4 ″ = 1′ 0″) whereas a detailed view may be drawn at 1:25 (1:24 or 1 ⁄ 2 ″ = 1′ 0″). Site plans are often drawn at 1:200 or 1:100. Scale is a nuanced subject in the use of engineering drawings.
The use of the vernier scale is shown on a vernier caliper which measures the internal and the external diameters of an object. The vernier scale is constructed so that it is spaced at a constant fraction of the fixed main scale. So for a vernier with a constant of 0.1, each mark on the vernier is spaced 9/10 of those on the main scale.