Search results
Results from the WOW.Com Content Network
For example, aligning the rightmost 1 on the C scale with 2 on the LL2 scale, 3 on the C scale lines up with 8 on the LL3 scale. To extract a cube root using a slide rule with only C/D and A/B scales, align 1 on the B cursor with the base number on the A scale (taking care as always to distinguish between the lower and upper halves of the A scale).
Bake for 1 ⁄ 2 hour. without requiring the use of bulky HTML markup. Please note that these templates do not handle preceding integers (or succeeding units) and the spacing in between, use {} for that: Bake for {{frac|2|1|2}} hours. Bake for 2 + 1 ⁄ 2 hours. As with {}, these templates should not be used in science or mathematical articles.
A slide rule consists of a body [note 1] and a slider that can be slid along within the body and both of these have numerical scales inscribed on them. On duplex rules the body and/or the slider have scales on the back as well as the front. [2] The slider's scales may be visible from the back or the slider may need to be slid right out and ...
The 1/4-turn shaft carries (also, each column) gears with 12, 16, and 20 teeth, for 3, 4, and 5. Digits [1] and [2] are handled by 12 and 24-tooth gears on the 1/12-revolution shaft. Practical design places the 12th-rev. shaft more distant, so the 1/4-turn shaft carries freely-rotating 24 and 12-tooth idler gears.
A scale ruler is a tool for measuring lengths and transferring measurements at a fixed ratio of length; two common examples are an architect's scale and engineer's scale. In scientific and engineering terminology, a device to measure linear distance and create proportional linear measurements is called a scale.
A ruler in combination with a letter scale. A ruler, sometimes called a rule, scale or a line gauge or meter stick, is an instrument used to make length measurements, whereby a length is read from a series of markings called "rules" along an edge of the device. [1] Usually, the instrument is rigid and the edge itself is a straightedge ("ruled ...
Diagrams are usually of a standard letter shape and size to conform to standards of encodings (e.g. DIN or ANSI). For example, in Finland the series used is 1.8 mm, 2.5 mm, 3.5 mm, 5.0 mm and 7.0 mm. Except for the very biggest ones, the templates are only suitable for technical pen drawing.
Various scales may be used for different drawings in a set. For example, a floor plan may be drawn at 1:50 (1:48 or 1 ⁄ 4 ″ = 1′ 0″) whereas a detailed view may be drawn at 1:25 (1:24 or 1 ⁄ 2 ″ = 1′ 0″). Site plans are often drawn at 1:200 or 1:100. Scale is a nuanced subject in the use of engineering drawings.