Search results
Results from the WOW.Com Content Network
The formal definition of calibration by the International Bureau of Weights and Measures (BIPM) is the following: "Operation that, under specified conditions, in a first step, establishes a relation between the quantity values with measurement uncertainties provided by measurement standards and corresponding indications with associated measurement uncertainties (of the calibrated instrument or ...
ISO/IEC 17025 General requirements for the competence of testing and calibration laboratories is the main standard used by testing and calibration laboratories. In most countries, ISO/IEC 17025 is the standard for which most labs must hold accreditation in order to be deemed technically competent.
A dead weight tester (DWT) is a calibration standard method that uses a piston cylinder on which a load is placed to make an equilibrium with an applied pressure underneath the piston. Deadweight testers are secondary standards which means that the pressure measured by a deadweight tester is defined through other quantities: length, mass and ...
The Pressure Equipment Directive (PED) 2014/68/EU (formerly 97/23/EC) [1] of the EU sets out the standards for the design and fabrication of pressure equipment ("pressure equipment" means steam boilers, pressure vessels, piping, safety valves and other components and assemblies subject to pressure loading) generally over one liter in volume and having a maximum pressure more than 0.5 bar gauge.
Part UW - Requirements for Pressure Vessels Fabricated by Welding; General: UW-1 through to UW-3; Materials: UW-5; Design: UW-8 through to UW-21; Fabrication: UW-26 through to UW-42; Inspection and Tests: UW-46 through to UW-54; Marking and Reports: UW-60; Pressure Relief Devices: UW-65; Part UF - Requirements for Pressure Vessels Fabricated by ...
To avoid liability, classification societies explicitly disclaim responsibility for the safety, fitness for purpose, or seaworthiness of the ship, but is a verification only that the vessel is in compliance with the classification standards of the society issuing the classification certificate.
Verification is intended to check that a product, service, or system meets a set of design specifications. [6] [7] In the development phase, verification procedures involve performing special tests to model or simulate a portion, or the entirety, of a product, service, or system, then performing a review or analysis of the modeling results.
The international prototype of the kilogram (IPK) is an artefact or prototype that was defined to have a mass of exactly one kilogram.. In metrology (the science of measurement), a standard (or etalon) is an object, system, or experiment that bears a defined relationship to a unit of measurement of a physical quantity. [1]