Ads
related to: pcb test points
Search results
Results from the WOW.Com Content Network
The two rows of holes (labelled #3) are test points used during the manufacture of this USB memory key. Testpoints on a printed circuit board (labelled E34, E35, E36, …) next to teardrop vias. A test point is a location within an electronic circuit that is used to monitor the state of the circuitry or inject test signals. [1]
A common form of in-circuit testing uses a bed-of-nails tester.This is a fixture that uses an array of spring-loaded pins known as "pogo pins". When a printed circuit board is aligned with and pressed down onto the bed-of-nails tester, the pins make electrical contact with locations on the circuit board, allowing them to be used as test points for in-circuit testing.
This is called electrical test or PCB e-test. A short is a connection between two points that should not be connected. An open is a missing connection between points that should be connected. [citation needed] For high-volume testing, a rigid needle adapter makes contact with copper lands on the board. [25]
Side view of a PCB showing a solder bead and test probe. Bead probe technology is a probing method used to connect electronic test equipment to the device under test (DUT) within a bed of nails fixture. The technique was first used in the 1990s [3] and originally given the name “Waygood Bump” after one of the main proponents, Rex Waygood.
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.
A PCB may be printed with a legend identifying the components, test points, or identifying text. Originally, silkscreen printing was used for this purpose, but today other, finer quality printing methods are usually used. Normally the legend does not affect the function of a PCBA.
Spring loaded pins are a component of the bed of nails tester. A bed of nails tester is a traditional electronic test fixture used for in-circuit testing.It has pins inserted into holes in an epoxy phenolic glass cloth laminated sheet (G-10) which are aligned using tooling pins to make contact with test points on a printed circuit board and are also connected to a measuring unit by wires.
One limitation in flying probe test methods is the speed at which measurements can be taken; the probes must be moved to each new test site on the board, and then a measurement must be completed. Bed-of-nails testers touch each test point simultaneously and electronic switching of instruments between test pins is more rapid than movement of probes.
Ads
related to: pcb test points