Search results
Results from the WOW.Com Content Network
Shrouded cable glands going into a flow meter. Split cable gland KVT for routing pre-terminated cables. A cable gland (more often known in the U.S. as a cord grip, cable strain relief, cable connector or cable fitting) is a device designed to attach and secure the end of an electrical cable to the equipment. [1]
Usually, the lines are fixed by clamping them into single cable clamps made of plastic or metal. Another possibility is to use so called cord grips which consist of weaved wire strands that put a grip around the cables. [3] A more cable-friendly alternative is attaching the lines to special strain relief plates using common cable ties. In case ...
In the electrical wiring of buildings, a cable tray system is used to support insulated electrical cables used for power distribution, control, and communication. Cable trays are used as an alternative to open wiring or electrical conduit systems, and are commonly used for cable management in commercial and industrial construction. They are ...
Twist-on wire connectors are a type of electrical connector used to fasten two or more low-voltage (or extra-low-voltage) electrical conductors. They are widely used in North America and several European countries in residential, commercial and industrial building power wiring, but have been banned in some other jurisdictions.
A cable laced wiring harness installed in a component of a Tesla coil Harness of car audio cables.. A cable harness, also known as a wire harness, wiring harness, cable assembly, wiring assembly or wiring loom, is an assembly of electrical cables or wires which transmit signals or electrical power. [1]
The splice of the copper pigtail to the existing aluminum wire can be accomplished with special crimp connectors, special miniature lug-type connectors, or approved twist-on connectors (with special installation procedures). Pig-tailing generally saves time and money, and is possible as long as the wiring itself is not damaged.
What’s more fun than second-guessing NFL coaches? Nothing, that’s what. So let’s do it every week, right here. Today: Whatever that was at the end of Bills-Rams.
Screw terminals, as individual connectors to a board at left, as a barrier strip with setscrews at top, and as a barrier strip with attached spade and loop lugs at bottom. A screw terminal is a type of electrical connection where a wire is held by the tightening of a screw .