enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. USB On-The-Go - Wikipedia

   en.wikipedia.org/wiki/USB_On-The-Go

   Micro-A adapters allow for connection to standard-A plugs, as used on fixed or standard devices. An OTG product must have a single micro-AB receptacle and no other USB receptacles. [5] [6] An OTG cable has a micro-A plug on one end, and a micro-B plug on the other end (it cannot have two plugs of the same type).

3. IOIO - Wikipedia

   en.wikipedia.org/wiki/IOIO

   IOIO-OTG pinout/connection diagram. The second-generation IOIO boards (known as IOIO-OTG) contain the following on-board features: [37] [38] [39] As the name suggests, a key feature of this generation is the introduction of USB-OTG, supporting USB master or slave mode. This enables the IOIO to connect to older Android phones that only support ...

4. USB hardware - Wikipedia

   en.wikipedia.org/wiki/USB_hardware

   The OTG device with the A-plug inserted is called the A-device and is responsible for powering the USB interface when required, and by default assumes the role of host. The OTG device with the B-plug inserted is called the B-device and by default assumes the role of peripheral. An OTG device with no plug inserted defaults to acting as a B-device.

5. USB-to-serial adapter - Wikipedia

   en.wikipedia.org/wiki/USB-to-serial_adapter

   A USB-to-serial adapter or simply USB adapter is a type of protocol converter that is used for converting USB data signals to and from serial communications standards (serial ports). Most commonly the USB data signals are converted to either RS-232 , RS-485 , RS-422 , or TTL-level UART serial data.

6. Lightning (connector) - Wikipedia

   en.wikipedia.org/wiki/Lightning_(connector)

   Apple offers various adapters that allow the Lightning connector to be used with other interfaces, such as 30-pin, USB, HDMI, VGA, and SD cards. The Lightning to 30-pin adapter supports only a limited subset of the available 30-pin signals: USB data, USB charging, and analog audio output (via the DAC inside of the adapter [27]).

7. USB - Wikipedia

   en.wikipedia.org/wiki/USB

   Ethernet standards require electrical isolation between the networked device (computer, phone, etc.) and the network cable up to 1500 V AC or 2250 V DC for 60 seconds. [116] USB has no such requirement as it was designed for peripherals closely associated with a host computer, and in fact it connects the peripheral and host grounds.