enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Multimeter - Wikipedia

   en.wikipedia.org/wiki/Multimeter

   For example, a multimeter using a moving coil movement with full-scale deflection current of 50 microamps (μA), the highest sensitivity commonly available, must draw at least 50 μA from the circuit under test for the meter to reach the top end of its scale. This may load a high-impedance circuit so much as to affect the circuit, thereby ...

3. Continuity test - Wikipedia

   en.wikipedia.org/wiki/Continuity_test

   In electronics, a continuity test is the checking of an electric circuit to see if current flows (that it is in fact a complete circuit). A continuity test is performed by placing a small voltage (wired in series with an LED or noise-producing component such as a piezoelectric speaker ) across the chosen path.

4. Current clamp - Wikipedia

   en.wikipedia.org/wiki/Current_clamp

   A digital clamp meter A multimeter with built-in clamp. Pushing the large button at the bottom opens the lower jaw of the clamp, allowing the clamp to be placed around a conductor. An electrical meter with integral AC current clamp is known as a clamp meter, clamp-on ammeter, tong tester, or colloquially as an amp clamp.

5. Electronic test equipment - Wikipedia

   en.wikipedia.org/wiki/Electronic_test_equipment

   Ammeter, e.g. Galvanometer or Milliammeter (Measures current) Multimeter e.g., VOM (Volt-Ohm-Milliammeter) or DMM (Digital Multimeter) (Measures all of the above) LCR meter - inductance (L), capacitance (C) and resistance (R) meter (measure LCR values) The following are used for stimulus of the circuit under test: Power supplies; Signal generator

6. Electrical isolation test - Wikipedia

   en.wikipedia.org/wiki/Electrical_isolation_test

   In electrical engineering, an electrical isolation test is a direct current (DC) or alternating current (AC) resistance test that is performed on sub-systems of an electronic system to verify that a specified level of isolation resistance is met. Isolation testing may also be conducted between one or more electrical circuits of the same ...

7. Continuity tester - Wikipedia

   en.wikipedia.org/wiki/Continuity_tester

   The indicator may be an electric light or a buzzer. [1] This led to the term "buzzing out a circuit" (which means to test for continuity) [3] Audible continuity buzzers or beepers are built into some models of multimeter, and the continuity setting is normally shared with the ohmmeter setting.

8. List of electrical and electronic measuring equipment

   en.wikipedia.org/wiki/List_of_electrical_and...

   Measures current Capacitance meter: Measures the capacitance component Current clamp: Measures current without physical connection Curve tracer: Applies swept signals to a device and allows display of the response Cos Phi Meter: Measures the power factor Distortionmeter: Measures the distortion added to a circuit Electricity meter

9. Current sensing - Wikipedia

   en.wikipedia.org/wiki/Current_sensing

   In electrical engineering, current sensing is any one of several techniques used to measure electric current. The measurement of current ranges from picoamps to tens of thousands of amperes. The selection of a current sensing method depends on requirements such as magnitude, accuracy, bandwidth, robustness, cost, isolation or size. The current ...