Ad
related to: remove weights from grandfather clock
Search results
Results from the WOW.Com Content Network
When moving or handling a "weight-driven clocks, it is advisable to wait until the clock has wound down before it is relocated. Once it has stopped running, carefully remove the weights and pendulum". [2] A clock "[...] should always be grasped at its most sturdy area" [2] and moved from one location to the next on its back.
Huygens' maintaining power in use. The weight drive used by Christiaan Huygens in his early clocks acts as a maintaining power. In this layout, the weight which drives the clock is carried on a pulley and the cord (or chain) supporting the weight is wrapped around the main driving wheel on one side and the rewinding wheel on the other.
In some precision clocks there is a smaller auxiliary weight on a threaded shaft to allow more fine adjustment. Tower clocks sometimes have a tray mounted on the pendulum rod, to which small weights can be added or removed, to adjust the rate without stopping the clock. The weight of the bob itself has little effect on the period of the
For premium support please call: 800-290-4726 more ways to reach us
A grandfather clock (also a longcase clock, tall-case clock, grandfather's clock, hall clock or floor clock) is a tall, freestanding, weight-driven pendulum clock, with the pendulum held inside the tower or waist of the case. Clocks of this style are commonly 1.8–2.4 metres (6–8 feet) tall with an enclosed pendulum and weights, suspended by ...
In some pendulum clocks, fine adjustment is done with an auxiliary adjustment, which may be a small weight that is moved up or down the pendulum rod. In some master clocks and tower clocks, adjustment is accomplished by a small tray mounted on the rod where small weights are placed or removed to change the effective length, so the rate can be ...
For gravity-driven clocks, the impulse force also increases as the driving weight falls and more chain suspends the weight from the gear train; in practice, however, this effect is only seen in large public clocks, and it can be avoided by a closed-loop chain. Watches and smaller clocks do not use pendulums as the timing device.
The foliot was a horizontal bar with weights near its ends affixed to a vertical bar called the verge which was suspended free to rotate. The verge escapement caused the foliot to oscillate back and forth about its vertical axis. [12] The rate of the clock could be adjusted by moving the weights in or out on the foliot.
Ad
related to: remove weights from grandfather clock