enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Standard cubic centimetres per minute - Wikipedia

   en.wikipedia.org/wiki/Standard_cubic_centimetres...

   Standard cubic centimeters per minute (SCCM) is a unit used to quantify the flow rate of a fluid. 1 SCCM is identical to 1 cm³ STP /min. Another expression of it would be Nml/min.

3. Vortex flowmeter - Wikipedia

   en.wikipedia.org/wiki/Vortex_flowmeter

   A vortex flowmeter has the following components: A flow sensor operable to sense pressure variations due to vortex-shedding of a fluid in a passage and to convert the pressure variations to a flow sensor signal, in the form of an electrical signal; and a signal processor operable to receive the flow sensor signal and to generate an output signal corresponding to the pressure variations due to ...

4. Standard litre per minute - Wikipedia

   en.wikipedia.org/wiki/Standard_litre_per_minute

   Until 1982, STP was defined as a temperature of 273.15 K (0 °C, 32 °F) and an absolute pressure of 101.325 kPa (1 atm). Since 1982, STP is defined as a temperature of 273.15 K (0 °C, 32 °F) and an absolute pressure of 100 kPa (1 bar). Conversions between each volume flow metric are calculated using the following formulas: Prior to 1982,

5. Flow coefficient - Wikipedia

   en.wikipedia.org/wiki/Flow_coefficient

   With C v = 1.0 and 200 psia inlet pressure, the flow is 100 standard cubic feet per minute (scfm). The flow is proportional to the absolute inlet pressure, so the flow in scfm would equal the C v flow coefficient if the inlet pressure were reduced to 2 psia and the outlet were connected to a vacuum with less than 1 psi absolute pressure (1.0 ...

6. Volumetric flow rate - Wikipedia

   en.wikipedia.org/wiki/Volumetric_flow_rate

   In most contexts a mention of rate of fluid flow is likely to refer to the volumetric rate. In hydrometry, the volumetric flow rate is known as discharge. Volumetric flow rate should not be confused with volumetric flux, as defined by Darcy's law and represented by the symbol q, with units of m 3 /(m 2 ·s), that is, m·s −1. The integration ...

7. Conversion of units - Wikipedia

   en.wikipedia.org/wiki/Conversion_of_units

   Flow rate of flue gas = 20 cubic metres per minute = 20 m 3 /min The flue gas exits the furnace at 0 °C temperature and 101.325 kPa absolute pressure. The molar volume of a gas at 0 °C temperature and 101.325 kPa is 22.414 m 3 /kmol.