Ad
related to: st1000dm010-2ep102 ata device windows 10
Search results
Results from the WOW.Com Content Network
In 1993, Seagate released the first Barracuda drive, with the ST11950. The drive had a capacity of 2.03 GB (1.69 GB formatted), was available with FAST SCSI-2 (N/ND models) or WIDE SCSI-2 (W/WD models) interface, and was the first hard drive ever to have a spindle speed of 7200-RPM.
ATATool must be run with administrator privileges. On Windows Vista and later it requires an elevated-privileges command prompt (see User Account Control). The target drive must be connected to a physical disk controller. The software will not work when using a hard drive through an external connection like USB or any external hard drive.
Hence, its protocol is usually ATA (a.k.a. PATA), SATA, SCSI, FC or SAS. The front-end interface communicates with a computer's host adapter (HBA, Host Bus Adapter) and uses: one of ATA, SATA, SCSI, FC; these are popular protocols used by disks, so by using one of them a controller may transparently emulate a disk for a computer.
Device configuration overlay (DCO) is a hidden area on many of today's hard disk drives (HDDs). Usually when information is stored in either the DCO or host protected area (HPA), it is not accessible by the BIOS (or UEFI ), OS , or the user.
The IDENTIFY DEVICE command queries a particular register on the IDE controller to establish the size of a drive. This register however can be changed using the SET MAX ADDRESS ATA command. If the value in the register is set to less than the actual hard drive size then effectively a host protected area is created.
Moving the HDD controller from the interface card to the disk drive helped to standardize the host/controller interface, reduce the programming complexity in the host device driver, and reduced system cost and complexity. The 40-pin IDE/ATA connection transfers 16 bits of data at a time on the data cable.
On the Windows platform, many programs designed to monitor and report S.M.A.R.T. information will function only under an administrator account. BIOS and Windows ( Windows Vista and later) may detect S.M.A.R.T. status of hard disk drives and solid state drives, and give a prompt if the S.M.A.R.T. status is bad.
The ATA/ATAPI sub-command for setting the level of AAM operation is an 8-bit value from 0 to 255. Most modern drives ship with the vendor-defined value of 0x00 in the acoustic management setting. This often translates to the max-performance value of 254 stated in the standard.
Ad
related to: st1000dm010-2ep102 ata device windows 10