Search results
Results from the WOW.Com Content Network
INT is an assembly language instruction for x86 processors that generates a software interrupt. It takes the interrupt number formatted as a byte value. [1] When written in assembly language, the instruction is written like this: INT X. where X is the software interrupt that should be generated (0-255).
Normally a character cell has 8 scan lines, 0–7. So, CX=0607h is a normal underline cursor, CX=0007h is a full-block cursor. If bit 5 of CH is set, that often means "Hide cursor". So CX=2607h is an invisible cursor. Some video cards have 16 scan lines, 00h-0Fh. Some video cards don't use bit 5 of CH. With these, make Start>End (e.g. CX=0706h)
A hardware interrupt is a condition related to the state of the hardware that may be signaled by an external hardware device, e.g., an interrupt request (IRQ) line on a PC, or detected by devices embedded in processor logic (e.g., the CPU timer in IBM System/370), to communicate that the device needs attention from the operating system (OS) [7] or, if there is no OS, from the bare metal ...
The descriptors may be either interrupt gates, trap gates or, for 32-bit protected mode only, task gates. Interrupt and trap gates point to a memory location containing code to execute by specifying both a segment (present in either the GDT or LDT) and an offset within that segment. The only difference between trap and interrupt gates is that ...
Under Microsoft Windows the APIC timer is not a shareable resource. [11] The aperiodic interrupts offered by the APIC timer are used by the Linux kernel tickless kernel feature. This optional but default feature is new with 2.6.18. When enabled on a computer with an APIC timer, the kernel does not use the 8253 programmable interval timer for ...
However, if it reads "32-bit operating system, x86-based processor," the computer does not support the 64-bit version of Windows. If the device can't run the 64-bit version, consider purchasing a ...
These instructions are also available in 32-bit mode, in which they operate on 32-bit registers (eax, ebx, etc.) and values instead of their 16-bit (ax, bx, etc.) counterparts. The updated instruction set is grouped according to architecture ( i186 , i286 , i386 , i486 , i586 / i686 ) and is referred to as (32-bit) x86 and (64-bit) x86-64 (also ...
The IRR specifies which interrupts are pending acknowledgement, and is typically a symbolic register which can not be directly accessed. The ISR register specifies which interrupts have been acknowledged, but are still waiting for an end of interrupt (EOI). The IMR specifies which interrupts are to be ignored and not acknowledged.