Ads
related to: shock absorber vs damperebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
A shock absorber or damper is a mechanical or hydraulic device designed to absorb and damp shock impulses. It does this by converting the kinetic energy of the shock into another form of energy (typically heat) which is then dissipated. Most shock absorbers are a form of dashpot (a damper which resists motion via viscous friction).
An active suspension is a type of automotive suspension that uses an onboard control system to control the vertical movement of the vehicle's wheels and axles relative to the chassis or vehicle frame, rather than the conventional passive suspension that relies solely on large springs to maintain static support and dampen the vertical wheel movements caused by the road surface.
A magnetorheological damper or magnetorheological shock absorber is a damper filled with magnetorheological fluid, which is controlled by a magnetic field, usually using an electromagnet. [ 1 ] [ 2 ] [ 3 ] This allows the damping characteristics of the shock absorber to be continuously controlled by varying the power of the electromagnet.
Mass dampers are frequently implemented with a frictional or hydraulic component that turns mechanical kinetic energy into heat, like an automotive shock absorber. Given a motor with mass m 1 attached via motor mounts to the ground, the motor vibrates as it operates and the soft motor mounts act as a parallel spring and damper, k 1 and c 1 .
A desert race vehicle, which must routinely absorb far higher impact forces, might be provided with pneumatic or hydro-pneumatic bump-stops. These are essentially miniature shock absorbers (dampers) that are fixed to the vehicle in a location, such, that the suspension will contact the end of the piston when it nears the upward travel limit.
Dashpots are commonly used in dampers and shock absorbers. The hydraulic cylinder in an automobile shock absorber is a dashpot. The hydraulic cylinder in an automobile shock absorber is a dashpot. They are also used on carburetors , where the return of the throttle lever is cushioned just before the throttle fully closes, then is allowed to ...
The spindle of the shock absorber now became the upper suspension pivot, usually double-ended. One of the last mass-production sports cars to still use lever arm shock absorbers was the MG B. [8] This had a lever arm shock absorber as the upper wishbone. A popular handling upgrade in later years was to fit telescopic shock absorbers instead.
As with all shock absorbers it usually consists of two parts: a spring, and a damper. The spring may be implemented with a steel or titanium coil, compressed air, or even an elastomer. The spring may be implemented with a steel or titanium coil, compressed air, or even an elastomer.
Ads
related to: shock absorber vs damperebay.com has been visited by 1M+ users in the past month