enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Modular connector - Wikipedia

    en.wikipedia.org/wiki/Modular_connector

    The 6P2C, 6P4C, and 6P6C modular connectors are probably best known for their use as RJ11, RJ14, and RJ25 non-powered registered jacks, respectively (and 6P4C and 6P6C for powered RJ11 and RJ14, power being delivered on the outer pairs). These interfaces use the same six-position modular connector body but have different numbers of pins installed.

  3. Telephone jack and plug - Wikipedia

    en.wikipedia.org/wiki/Telephone_jack_and_plug

    Modular connectors are specified for the registered jack (RJ) series of connectors, as well as for Ethernet and other connectors, such as 4P4C (4 position, 4 contacts) modular connectors, the de facto standard on handset cords, [2] often improperly [3] [4] referred to as RJ connectors.

  4. Registered jack - Wikipedia

    en.wikipedia.org/wiki/Registered_jack

    For example, RJ11 and RJ14 use female six-position modular connectors, and RJ21 uses a 25-pair (50-pin) miniature ribbon connector. RJ11 uses two conductors in a six-position female modular connector, so can be made with any female six-position modular connector, while RJ14 uses four, so can be made with either a 6P4C or a 6P6C connector.

  5. ANSI/TIA-568 - Wikipedia

    en.wikipedia.org/wiki/ANSI/TIA-568

    Perhaps the most comprehensive known and most discussed feature of ANSI/TIA-568 is the definition of the pin-to-pair assignments, or pinout, between the pins in a connector (a plug or a socket) and the wires in a cable. Pinouts are critical because cables do not function if the pinouts at their two ends aren't correctly matched.

  6. British telephone socket - Wikipedia

    en.wikipedia.org/wiki/British_telephone_socket

    The 'old style' fixed master socket had only one set of terminals on the back and customers were supposed to use extension kits plugged into the front socket; however, many customers hard-wired their own extensions anyway for neatness and robustness reasons, which was a poor arrangement since it provided no way to isolate the customer's ...

  7. GG45 - Wikipedia

    en.wikipedia.org/wiki/GG45

    GG45 Connector. GG45 (GigaGate 45) and ARJ45 (Augmented RJ45) are two related connectors for Category 7, Category 7 A, and Category 8 telecommunication cabling. The GG45 interface and related implementations are developed and sold by Nexans S.A., while the ARJ45 interface and related implementations are developed and sold by Bel Fuse Inc.

  8. List of video connectors - Wikipedia

    en.wikipedia.org/wiki/List_of_video_connectors

    Where BNC is used, available as 3 connectors with Sync on Green, or 5 connector Red / Green / Blue / Horizontal Sync / Vertical sync. Mac-II/Quadra DA15F: 1152 × 870 @ 75 [8] Macintosh: Mac-DA15F and Sun-13W3 were similar in capability to VGA. Some Sun machines used 4 or 5 BNC connectors to transfer video signal. 1990: 13W3 DB13W3: 1152 × 900 ...

  9. Phone connector (audio) - Wikipedia

    en.wikipedia.org/wiki/Phone_connector_(audio)

    EIA RS-453: Dimensional, Mechanical and Electrical Characteristics Defining Phone Plugs & Jacks standard of 0.206 in (5.2 mm) diameter, also found in IEC 60603-11:1992 Connectors for frequencies below 3 MHz for use with printed boards – Part 11: Detail specification for concentric connectors (dimensions for free connectors and fixed connectors).