Search results
Results from the WOW.Com Content Network
Servo and receiver connections A diagram showing typical PWM timing for a servomotor. Servo control is a method of controlling many types of RC/hobbyist servos by sending the servo a PWM (pulse-width modulation) signal, a series of repeating pulses of variable width where either the width of the pulse (most common modern hobby servos) or the duty cycle of a pulse train (less common today ...
A radio-controlled aircraft (often called RC aircraft or RC plane) is a small flying machine that is radio controlled by an operator on the ground using a hand-held radio transmitter. The transmitter continuously communicates with a receiver within the craft that sends signals to servomechanisms (servos) which move the control surfaces based on ...
The servo is controlled by three wires: ground, power, and control. The servo will move based on the pulses sent over the control wire, which set the angle of the actuator arm. The servo expects a pulse every 20 ms in order to gain correct information about the angle. The width of the servo pulse dictates the range of the servo's angular motion.
Radio-controlled car. Radio-controlled cars, or RC cars for short, [1] are miniature vehicles (cars, vans, buses, buggies, etc.) controlled via radio. Nitro powered models use glow plug engines, small internal combustion engines fuelled by a special mixture of nitromethane, methanol, and oil (in most cases a blend of castor oil and synthetic oil).
Radio control (often abbreviated to RC) is the use of control signals transmitted by radio to remotely operate a device. Examples of simple radio control systems are garage door openers and keyless entry systems for vehicles, in which a small handheld radio transmitter unlocks or opens doors. Radio control is also used for control of model ...
A standard RC receiver (or a microcontroller) sends pulse-width modulation (PWM) signals to the servo. The electronics inside the servo translate the width of the pulse into a position. When the servo is commanded to rotate, the motor is powered until the potentiometer reaches the value corresponding to the commanded position.
Learning to fly a collective pitch RC helicopter takes time and practice. Many modelers join a club so they can be instructed by experienced RC pilots, or follow on-line guides. [12] RC Helicopters usually have at least four controls: roll - cyclic pitch, elevator (fore-aft cyclic pitch), rudder (yaw) and pitch/throttle (collective pitch/power ...
Electronic speed controls for model RC vehicles may incorporate a battery eliminator circuit to regulate voltage for the receiver, removing the need for separate receiver batteries. The regulator may be linear or switched mode. ESCs, in a broader sense, are PWM controllers for electric motors. The ESC generally accepts a nominal 50 Hz PWM servo ...