Search results
Results from the WOW.Com Content Network
Existence of a safety problem. All work in production line is stopped until a solution has been found. The alerts may be logged to a database so that they can be studied as part of a continual improvement process. Once the problem is troubleshot and fixed, a second pull of the andon cord authorizes the production to be resumed.
The most common use of a pull switch is to operate a ceiling electric light.The ceiling fan and mechanical wall fans are also appliances often operated by pull switches. . Pull switches may be either two-position (open or closed) or multi-position (allowing for different fan speeds or levels of illuminati
A safety wire is used to ensure proper security for a fastener. The wire needed is long enough to reach from a fixed location to a hole in the removable fastener, such as a pin — a clevis fastener, sometimes a linchpin or hitch-pin through a clevis yoke for instance — and the wire pulled back upon itself, parallel to its other end, then twisted, a single end inserted through a fastener ...
Wiring is subject to safety standards for design and installation. Allowable wire and cable types and sizes are specified according to the circuit operating voltage and electric current capability, with further restrictions on the environmental conditions, such as ambient temperature range, moisture levels, and exposure to sunlight and chemicals.
An output signal switching device (OSSD) is an electronic device used as part of the safety system of a machine. It provides a coded signal which, when interrupted due to a safety event, signals the machine to shut down. It works by converting the standard direct current supply, usually 24 volts, into two pulsed and out-of-phase signals.
A conveyor belt is the carrying medium of a belt conveyor system (often shortened to a belt conveyor). A belt conveyor system consists of two or more pulleys (sometimes referred to as drums), with a closed loop of carrying medium—the conveyor belt—that rotates about them. One or both of the pulleys are powered, moving the belt and the ...
A conveyor system is often the lifeline to a company's ability to effectively move its product in a timely fashion. The steps that a company can take to ensure that it performs at peak capacity, include regular inspections and system audits, close monitoring of motors and reducers, keeping key parts in stock, and proper training of personnel.
Safety relays must always be designed in such a way that, if wired correctly, neither a fault in the device nor an external fault caused by the sensor or actuator will lead to the loss of the safety function. [8] A normal relay uses a wire coil and the mechanical movement of the metal contacts to switch the load on and off.