Search results
Results from the WOW.Com Content Network
This is known as inter-VLAN routing. On layer-3 switches it is accomplished by the creation of layer-3 interfaces (SVIs). Inter VLAN routing, in other words routing between VLANs, can be achieved using SVIs. [1] SVI or VLAN interface, is a virtual routed interface that connects a VLAN on the device to the Layer 3 router engine on the same device.
Router R1 is a one-armed router carrying out inter-VLAN routing. A router on a stick, also known as a one-armed router, [1] [2] is a router that has a single physical or logical connection to a network. It is a method of inter-VLAN routing where one router is connected to a switch via a single cable. The router has physical connections to the ...
With a VLAN Management Policy Server (VMPS), an administrator can assign switch ports to VLANs dynamically based on information such as the source MAC address of the device connected to the port or the username used to log onto that device. As a device enters the network, the switch queries a database for the VLAN membership of the port that ...
The switch forwards all frames received from a private port to the uplink port, regardless of VLAN ID or destination MAC address. Frames received from an uplink port are forwarded in the normal way (i.e. to the port hosting the destination MAC address, or to all ports of the VLAN for broadcast frames or for unknown destination MAC addresses).
A VLAN access control list (VACL) provides access control for all packets that are bridged within a VLAN or that are routed into or out of a VLAN. Unlike regular Cisco IOS access control lists that are configured on router interfaces and applied on routed packets only, VACLs apply to all packets.
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
Simply do not put any hosts on VLAN 1 (the default VLAN). i.e., assign an access VLAN other than VLAN 1 to every access port Switch (config-if)# switchport access vlan 2; Change the native VLAN on all trunk ports to an unused VLAN ID. Switch (config-if)# switchport trunk native vlan 999; Explicit tagging of the native VLAN on all trunk ports.
Prior to supporting standardized IEEE 802.1Q tagging, 3Com used proprietary Virtual LAN Trunking (VLT). [5] 3Com VLT supported VLAN IDs 1–16 with 15 being reserved for Autoselect VLAN Mode (where a VLAN server decides port membership) and 16 reserved for Spanning Tree Protocol.