Search results
Results from the WOW.Com Content Network
ping is a computer network administration software utility used to test the reachability of a host on an Internet Protocol (IP) network. It is available in a wide range of operating systems – including most embedded network administration software.
Then, the command ipconfig /renew is executed to request a new IP address. [ 3 ] [ 4 ] Where a computer is connected to a cable or DSL modem, it may have to be plugged directly into the modem network port to bypass the router, before using ipconfig /release and turning off the power for a period of time, to ensure that the old IP address is ...
The advantages of PathPing over ping and traceroute are that each node is pinged as the result of a single command, and that the behavior of nodes is studied over an extended time period, rather than the default ping sample of four messages or default traceroute single route trace. The disadvantage is that it takes a total of 25 seconds per hop ...
Paping (pronounced pah ping) is a computer network administration utility used to test the reachability of a host on an Internet Protocol (TCP/IP) network and to measure the time it takes to connect to a specified port. The name is a play on the word ping, another computer network administration utility.
Local Address – The IP address of the local computer and the port number being used. The name of the local computer that corresponds to the IP address and the name of the port is shown unless the -n parameter is specified. An asterisk (*) is shown for the host if the server is listening on all interfaces.
Cisco's implementation of traceroute also uses a sequence of UDP datagrams, each with incrementing TTL values, to an invalid port number at the remote host; by default, UDP port 33434 is used. An extended version of this command (known as the extended traceroute command) can change the destination port number used by the UDP probe messages. [13]
Command-Line Reference : Microsoft TechNet Database "Command-Line Reference" The MS-DOS 6 Technical Reference on TechNet contains the official Microsoft MS-DOS 6 command reference documentation. DR-DOS 7.03 online manual; MDGx MS-DOS Undocumented + Hidden Secrets; MS-DOS v1.25 and v2.0 source code
COMMAND: The command to run (add, delete, change, get, monitor, flush)-net: <dest> is a network address-host: <dest> is host name or address (default)-netmask: the mask of the route <dest>: IP address or host name of the destination <gateway>: IP address or host name of the next-hop router