Search results
Results from the WOW.Com Content Network
The DisplayPort standard does not specify any maximum length for cables, though the DisplayPort 1.2 standard does set a minimum requirement that all cables up to 2 meters in length must support HBR2 speeds (21.6 Gbit/s), and all cables of any length must support RBR speeds (6.48 Gbit/s).
The modern DE-15 connector can carry Display Data Channel to allow the monitor to communicate with the graphics card, and optionally vice versa. [1] Being replaced by DVI from 1999 onward. DB13W3: Analog computer video, color and monochrome. Sun Microsystems, Silicon Graphics, IBM RISC, Intergraph and some Apple Computer computer workstations.
Networking cable is a piece of networking hardware used to connect one network device to other network devices or to connect two or more computers to share devices such as printers or scanners. Different types of network cables, such as coaxial cable , optical fiber cable , and twisted pair cables, are used depending on the network's topology ...
In January 2013, Apple reduced the price of their 2 m (6.6 ft) length cable to US$39 and added a half-meter cable for US$29. [ 164 ] In Thunderbolt 3's introduction, Intel announced passive USB-C cables would connect Thunderbolt devices at speeds greater than USB 3.1 (though less than active Thunderbolt cables), thereby eliminating the adoption ...
In addition to digital, some DVI connectors also have pins that pass an analog signal, which can be used to connect an analog monitor. The analog pins are the four that surround the flat blade on a DVI-I or DVI-A connector. A VGA monitor, for example, can be connected to a video source with DVI-I through the use of a passive adapter. Since the ...
An HDMI cable is composed of four shielded twisted pairs, with impedance of the order of 100 Ω (±15%), plus seven separate conductors. HDMI cables with Ethernet differ in that three of the separate conductors instead form an additional shielded twisted pair (with the CEC/DDC ground as a shield). [51]: §HEAC-2.9
A cable terminated according to T568A on one end and T568B on the other is a crossover cable when used with the earlier twisted-pair Ethernet standards that use only two of the pairs because the pairs used happen to be pairs 2 and 3, the same pairs on which T568A and T568B differ. Crossover cables are occasionally needed for 10BASE-T and ...
Ethernet cables (12 P) M. M.2 (1 P) Pages in category "Computer connectors" The following 52 pages are in this category, out of 52 total.