enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Kingpin (automotive part) - Wikipedia

   en.wikipedia.org/wiki/Kingpin_(automotive_part)

   The steering kingpin is held in place by the forked ends of a beam axle on a Ford Model T. The kingpin (also king-pin, king pin and k pin) [1] [2] is the main pivot in the steering mechanism of a car or other vehicle. The term is also used to refer to part of a fifth wheel coupling apparatus for a semi and its trailer or other load.

3. Beam axle - Wikipedia

   en.wikipedia.org/wiki/Beam_axle

   A beam axle, rigid axle, or solid axle is a dependent suspension design in which a set of wheels is connected laterally by a single beam or shaft. Beam axles were once commonly used at the rear wheels of a vehicle, but historically, they have also been used as front axles in four-wheel-drive vehicles. In most automobiles, beam axles have been ...

4. Sliding pillar suspension - Wikipedia

   en.wikipedia.org/wiki/Sliding_pillar_suspension

   1908 Sizaire-Naudin Schematic of a later 'inverted' sliding pillar, as for the Morgan. A sliding pillar suspension is a form of independent front suspension for light cars. The stub axle and wheel assembly are attached to a vertical pillar or kingpin which slides up and down through a bush or bushes which are attached to the vehicle chassis, usually as part of transverse outrigger assemblies ...

5. Car suspension - Wikipedia

   en.wikipedia.org/wiki/Car_suspension

   A dependent suspension normally has a beam (a simple 'cart' axle) or a (driven) live axle that holds wheels parallel to each other and perpendicular to the axle. When the camber of one wheel changes, the camber of the opposite wheel changes in the same way (by convention, on one side, this is a positive change in the camber, and on the other ...

6. Independent suspension - Wikipedia

   en.wikipedia.org/wiki/Independent_suspension

   Independent suspension is any automobile suspension system that allows each wheel on the same axle to move vertically (i.e. reacting to a bump on the road) independently of the others. This is contrasted with a beam axle or deDion axle system in which the wheels are linked. "Independent" refers to the motion or path of movement of the wheels or ...

7. Anti-roll bar - Wikipedia

   en.wikipedia.org/wiki/Anti-roll_bar

   Understeer or oversteer can be reduced by changing the proportion of the total roll stiffness that comes from the front and rear axles. Increasing it at the front increases the proportion of the total load transfer that the front axle reacts to—and decreases it in the rear. In general, this makes the outer front wheel run at a comparatively ...