Search results
Results from the WOW.Com Content Network
Aggregation causes sedimentation or creaming, therefore the colloid is unstable: if either of these processes occur the colloid will no longer be a suspension. Examples of a stable and of an unstable colloidal dispersion. Electrostatic stabilization and steric stabilization are the two main mechanisms for stabilization against aggregation.
An example of a suspension would be sand in water. The suspended particles are visible under a microscope and will settle over time if left undisturbed. This distinguishes a suspension from a colloid , in which the colloid particles are smaller and do not settle. [ 2 ]
Although suspensions are relatively simple to distinguish from solutions and colloids, it may be difficult to distinguish solutions from colloids since the particles dispersed in the medium may be too small to distinguish by the human eye. Instead, the Tyndall effect is used to distinguish solutions and colloids. Due to the various reported ...
The depletion force is an effect of increased osmotic pressure in the surrounding solution. When colloids get sufficiently close, that is when their excluded volumes overlap, depletants are expelled from the interparticle region. This region between colloids then becomes a phase of pure solvent. When this occurs, there is a higher depletant ...
Colloidal chemistry (5 C, 125 P) A. Aerosols (5 C, 35 P) G. Gels (2 C, 24 P) Pages in category "Colloids" The following 29 pages are in this category, out of 29 total.
The subunits of colloidal silica particles are typically in the range of 1 to 5 nm. Whether or not these subunits are joined depends on the conditions of polymerization. Initial acidification of a water-glass (sodium silicate) solution yields Si(OH) 4. If the pH is reduced below 7 or if salt is added, then the units tend to fuse together in chains.
This category has the following 5 subcategories, out of 5 total. ... (surface science) ... Interface and colloid science; Ion vibration current;
A sol is a colloidal suspension made out of tiny solid particles [1] in a continuous liquid medium. Sols are stable, so that they do not settle down when left undisturbed, and exhibit the Tyndall effect, which is the scattering of light by the particles in the colloid. The size of the particles can vary from 1 nm - 100 nm.