Search results
Results from the WOW.Com Content Network
Double-sideband suppressed-carrier transmission (DSB-SC) is transmission in which frequencies produced by amplitude modulation (AM) are symmetrically spaced above and below the carrier frequency and the carrier level is reduced to the lowest practical level, ideally being completely suppressed. [1] In the DSB-SC modulation, unlike in AM, the ...
Reduced-carrier transmission is an amplitude modulation (AM) transmission in which the carrier signal level is reduced to reduce wasted electrical power. Suppressed-carrier transmission is a special case in which the carrier level is reduced below that required for demodulation by a normal receiver .
Categorization for signal modulation based on data and carrier types. In electronics and telecommunications, modulation is the process of varying one or more properties of a periodic waveform, called the carrier signal, with a separate signal called the modulation signal that typically contains information to be transmitted. [1]
In the Armstrong method, the audio signal and the radio frequency carrier signal are applied to the balanced modulator to generate a double sideband suppressed carrier signal. The phase of this output signal is then shifted 90 degrees with respect to the original carrier. The balanced modulator output can either lead or lag the carrier's phase.
Double-sideband reduced carrier transmission (DSB-RC): transmission in which (a) the frequencies produced by amplitude modulation are symmetrically spaced above and below the carrier and (b) the carrier level is reduced for transmission at a fixed level below that which is provided to the modulator.
The first such analog modulating waveforms applied to radio carriers were human voice signals picked up by microphone sensors and applied to the carrier waveforms. The resulting analog voice modes are known today as: Amplitude modulation (AM) Double-sideband suppressed carrier (DSB-SC) Independent sideband (ISB) Single sideband (SSB)
A Costas loop is a phase-locked loop (PLL) based circuit which is used for carrier frequency recovery from suppressed-carrier modulation signals (e.g. double-sideband suppressed carrier signals) and phase modulation signals (e.g. BPSK, QPSK). It was invented by John P. Costas at General Electric in the 1950s.
Single-sideband modulation with full carrier (H2A/H2B) is another form of modulated CW (MCW). Amateur radio operators may also use A2A to transmit Morse code, however it would be more typical to send it as CW, rather than MCW, using single-sideband modulation with a suppressed carrier, which reduces the bandwidth and power requirements.