Ads
related to: fast charger circuit
Search results
Results from the WOW.Com Content Network
Quick Charge is a proprietary technology that can charge battery-powered devices, primarily mobile phones, at power levels exceeding the 7.5 watts (5 volts at 1.5 amps) supported by the USB BC 1.2 standard, using existing USB cables.
The charger may have temperature or voltage sensing circuits and a microprocessor controller to safely adjust the charging current and voltage, determine the state of charge, and cut off at the end of charge. Chargers may elevate the output voltage proportionally with current to compensate for impedance in the wires. [3]
Trickle charging is the process of charging a fully charged battery at a rate equal to its self-discharge rate, enabling the battery to remain at its fully charged level. This state occurs almost exclusively when the battery is not loaded, as trickle charging will not keep a battery charged if current is being drawn by a load.
A CCS1 (Combined Charging Standard 1) DC charging connector, which is used in North America. It is an extension of the J1772 standard AC charging connector. CCS Combo 1 vehicle inlet showing the J1772 and the two DC fast-charging pins Connectors: Combo 2 (left), compared to IEC Type 2 (right). Two large direct current (DC) pins are added below ...
The first specification of this time reached a maximum of 125 A with up to 500 V. The typical Chademo charging stations allowing for 50 kW direct current became the basis for the term fast charging. When the Nissan Leaf came around in 2010, having a range of up to 160 km (100 miles), the concept of an actual fast charging networks was developed.
Very roughly, and with many exceptions and caveats, restoring a battery's full capacity in one hour or less is considered fast charging. A battery charger system will include more complex control-circuit- and charging strategies for fast charging, than for a charger designed for slower recharging.
Ads
related to: fast charger circuit