enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Nut (hardware) - Wikipedia

   en.wikipedia.org/wiki/Nut_(hardware)

   Acorn nut (cap nut) Crown hex nut, blind nut, cap nut, domed cap nut, or dome nut A nut that has a domed end on one side Barrel nut: Steel cross dowel or dowel nut, cross dowel (woodworking) A round slug or formed sheet metal part with threads perpendicular to the length of the nut Cage nut: Caged nut, captive nut, clip nut

3. Flange nut - Wikipedia

   en.wikipedia.org/wiki/Flange_nut

   A self-aligning nut, also known as a spherical nut [2] or leveling nut, is a type of nut used in applications where the fastener is not perpendicular to the surface to which the nut anchors. A flange nut is used inside a specially shaped dished-out washer. The device is commonly used in the aerospace industry.

4. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole should be 1/2" longer than the depth penetration of the screw.

5. Split beam nut - Wikipedia

   en.wikipedia.org/wiki/Split_beam_nut

   A split beam nut, also known as a split hex nut [1] or slotted beam nut, [2] is a locknut with slots cut in the top that separate the outside end into two [3] or more sections that are bent slightly inward, making the thread diameter undersized in the slotted portion.

6. Bolt (fastener) - Wikipedia

   en.wikipedia.org/wiki/Bolt_(fastener)

   Shoulder bolt or stripper bolt - Bolt with a broad smooth shank and small threaded section at the end used as a pivot pin or attachment point. U-bolt - Bolt shaped like the letter U where the two straight sections are threaded. A straight metal plate with two bolt holes is used with nuts to hold pipes or other round objects to the U-bolt.

7. Set screw - Wikipedia

   en.wikipedia.org/wiki/Set_screw

   On a shaft, this may be simply a flattened area. A set screw may have any type of drive, such as hex or square head, slot, or recessed --- cross (Phillips), hex (Allen), star (Torx), or square (Robertson). In the UK, the term "set screw" or "setscrew" refers simply to a bolt which is fully threaded, with no smooth shank; called cap screw in the US.

8. Insert nut - Wikipedia

   en.wikipedia.org/wiki/Insert_nut

   The screw-in insert nuts come in various sizes and take different screw sizes. For example, an M6 insert nut will take an M6 bolt, a "1/4-20" insert nut will take a 1/4-20 inch bolt., etc The pre-drilled hole must be as deep as the length of the insert nut plus any portion of the bolt that may be screwed past the end of the nut in the work piece.

9. Acorn nut - Wikipedia

   en.wikipedia.org/wiki/Acorn_nut

   An acorn nut. An acorn nut, also referred to as crown hex nut, blind nut, cap nut, domed cap nut, or dome nut (UK), is a nut that has a domed end on one side. When used together with a threaded fastener with an external male thread, the domed end encloses the external thread, either to protect the thread or to protect nearby objects from contact with the thread.