Search results
Results from the WOW.Com Content Network
1:128: 3 ⁄ 32 in: 2.381 mm A few rockets and some fit-in-the-box aircraft are made to this size. 1:120: 0.1 in: 2.54 mm: Model railways (TT) Derived from the scale of 1 inch equals 10 feet.TT model railroad scale. Used in AD&D Battlesystem Skirmishes rules. Works with 15 mm miniatures where a 6 foot man would equal 15.24 mm 1:110: 2.771 mm
This battery contained two independent 4.5 V batteries, and had a four-pin connector. 9 V with a center tap was available by wiring in series. There were two ⌀3.2 mm negative pins spaced 9.5 mm apart and two ⌀4.0 mm positive pins spaced 14.3 mm apart. Negative and positive pins were spaced 18.1 mm apart.
Engineering G size is 22 + 1 ⁄ 2 in (572 mm) high, but it is a roll format with a variable width up to 90 in (2.3 m) in increments of 8 + 1 ⁄ 2 in (216 mm). Engineering H through N sizes are also roll formats.
So a 1 / 2 in (12.7 mm) diameter drill will be able to drill a hole 4 + 1 / 2 in (114.3 mm) deep, since it is 9 times the diameter in length. A 1 / 8 in (3.175 mm) diameter drill can drill a hole 1 + 5 / 8 in (41.275 mm) deep, since it is 13 times the diameter in flute length. [3]
Fine julienne; measures approximately 1 ⁄ 16 by 1 ⁄ 16 by 1–2 inches (0.2 cm × 0.2 cm × 3 cm–5 cm), and is the starting point for the fine brunoise cut. [ 1 ] Chiffonade ; rolling leafy greens and slicing the roll in sections from 4–10mm in width
Metric size American system Continental system Chinese system ... 3 + 1 / 2 ≈ 1.235 mm: Ruby Brilliant [12] 4 ≈ 1.411 mm: Brilliant Perle: Diamant ...
The French scale measures and is proportional to the outer diameter of a catheter, with 1 French (Fr) defined as 1 ⁄ 3 millimeter, making the relationship: 1 mm = 3 Fr. Thus, the outer diameter of a catheter in millimeters can be calculated by dividing the French size by 3. [ 2 ]
Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.