Search results
Results from the WOW.Com Content Network
Engineering G size is 22 + 1 ⁄ 2 in (572 mm) high, but it is a roll format with a variable width up to 90 in (2.3 m) in increments of 8 + 1 ⁄ 2 in (216 mm). Engineering H through N sizes are also roll formats.
Although the most common medium format film, the 120 roll, is 6 cm (2.4 in) wide, and is most commonly shot square, the most common "medium-format" digital sensor sizes are approximately 48 mm × 36 mm (1.9 in × 1.4 in), which is roughly twice the size of a full-frame DSLR sensor format.
The alternative Super series, denoted SnR, nR Plus or nR+, has an aspect ratio of 3∶2 (or as close as possible) and thus provides a better fit for standard 135 film (35 mm) at sizes of 8 inches or above. 5R is twice the size of a 2R print, 6R twice the size of a 4R print and S8R twice the size of 6R. 4D/6D is a newer size for most consumer ...
1:128: 3 ⁄ 32 in: 2.381 mm A few rockets and some fit-in-the-box aircraft are made to this size. 1:120: 0.1 in: 2.54 mm: Model railways (TT) Derived from the scale of 1 inch equals 10 feet.TT model railroad scale. Used in AD&D Battlesystem Skirmishes rules. Works with 15 mm miniatures where a 6 foot man would equal 15.24 mm 1:110: 2.771 mm
(E.g. 1 mm diameter wire is ~18 AWG, 2 mm diameter wire is ~12 AWG, and 4 mm diameter wire is ~6 AWG). This quadruples the cross-sectional area and conductance. A decrease of ten gauge numbers (E.g. from 12 AWG to 2 AWG) multiplies the area and weight by approximately 10, and reduces the electrical resistance (and increases the conductance ) by ...
A less precise definition is one pica equals 0.166 inches (4.2 mm), and one point 0.01383 inches (0.351 mm). [ 27 ] [ 33 ] It was also noticed that 83 picas is nearly equal to 35 cm, so the Type Founders Association also suggested using a 35 cm metal rod for measurements, but this was not accepted by every foundry.
Originally in 1945, the divisions were based on the ring inside diameter in steps of 1 ⁄ 64 inch (0.40 mm). [6] However, in 1987 BSI updated the standard to the metric system so that one alphabetical size division equals 1.25 mm of circumferential length.
Although metric, based on the A4 paper size, and named to suggest that it is part of the official ISO 216 paper sizes, it is only a de facto standard. It is often referred to as (metric) "foolscap" or "folio" because of its similarity to the traditional foolscap folio size of 8 + 1 ⁄ 2 in × 13 + 1 ⁄ 2 in (216 mm × 343 mm).