Search results
Results from the WOW.Com Content Network
The adhesive bonds the touch panel to the main liquid crystal display, and also bonds any protective cover, such as the lens, to the touch panel. After application, the adhesive is cured onto the device through ultraviolet light (UV), heat, moisture, or a combination, depending on the manufacturer and specifications. Major applications include ...
In contrast, pressure-sensitive adhesives (PSAs) form a bond simply by the application of light pressure to marry the adhesive with the adherend. Pressure-sensitive adhesives are designed with a balance between flow and resistance to flow. The bond forms because the adhesive is soft enough to flow, or wet, the adherend.
The resolution of liquid crystal sensors is in the 0.1 °C (0.2 °F) range. Disposable liquid crystal thermometers have been developed for home and medical use. For example if the thermometer is put onto someone's forehead, it will change colour depending on the temperature of the person's body. There are two stages in the liquid crystals:
The disadvantage of the lack of instantaneous bonding exhibited by many adhesives can be overcome by using a suitable fast-curing adhesive or a combination of a standard adhesive with a second, fast-curing adhesive (e.g. double-sided adhesive tape) or with another joining method, such as spot welding, rivets, screws, or clinching / press ...
If the adhesive is to be used within six months, it is not necessary to refrigerate it. Cyanoacrylates are moisture-sensitive, and moving from a cool to a hot location will create condensation; after removing from the refrigerator, it is best to let the adhesive reach room temperature before opening. After opening, it should be used within 30 days.
Too low a temperature can cause the polymeric adhesive to enter its glass state becoming very brittle and reducing adhesion. [14] Raising the temperature, on the other hand, causes the polymer to become more fluid and mobile. As the mobility increases, the polymer adhesion is reduced as the polymer starts to flow as opposed to adhere.
When potting a circuit board that uses surface-mount technology, low glass transition temperature (T g) potting compounds such as polyurethane or silicone may be used. High T g potting compounds may break solder bonds through solder fatigue by hardening at a higher temperature because the coating then shrinks as a rigid solid over a larger part ...
Structural adhesives can be used to create load-bearing joints. Although many adhesives such as sealants, hot melt adhesives and even acrylic foam tapes can bear loads, the term structural adhesive is typically used where joints will have lap shear strength greater than 1450 psi. [3] The different types of structural adhesives are: Epoxies