Search results
Results from the WOW.Com Content Network
In a system using segmentation, computer memory addresses consist of a segment id and an offset within the segment. [3] A hardware memory management unit (MMU) is responsible for translating the segment and offset into a physical address, and for performing checks to make sure the translation can be done and that the reference to that segment and offset is permitted.
For example, in the tiny model CS=DS=SS, that is the program's code, data, and stack are all contained within a single 64 KB segment. In the small memory model DS=SS, so both data and stack reside in the same segment; CS points to a different code segment of up to 64 KB.
However, on the 80386, with its paged memory management unit it is possible to protect individual memory pages against writing. [4] [5] Memory models are not limited to 16-bit programs. It is possible to use segmentation in 32-bit protected mode as well (resulting in 48-bit pointers) and there exist C language compilers which support that. [6]
Each segment was placed at a specific location in memory by the software being executed and all instructions that operated on the data within those segments were performed relative to the start of that segment. This allowed a 16-bit address register, which would normally be able to access 64 KB of memory space, to access 1 MB of memory space.
Unlike virtual storage—paging or segmentation, rollout/rollin does not require any special memory management hardware; however, unless the system has relocation hardware such as a memory map or base and bounds registers, the program must be rolled back in to its original memory locations. Rollout/rollin has been largely superseded by virtual ...
As mentioned, by working under VM86 mode the segmentation mechanism is reconfigured to work just like under real mode, but the paging mechanism is still active, and it is transparent to the real mode code; thus, memory protection is still applicable, and so is the isolation of the address space.
Flat memory model or linear memory model refers to a memory addressing paradigm in which "memory appears to the program as a single contiguous address space." [ 1 ] The CPU can directly (and linearly ) address all of the available memory locations without having to resort to any sort of bank switching , memory segmentation or paging schemes.
Memory architecture also explains how binary digits are converted into electric signals and then stored in the memory cells. And also the structure of a memory cell. For example, dynamic memory is commonly used for primary data storage due to its fast access speed.