enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. South High Community School - Wikipedia

   en.wikipedia.org/wiki/South_High_Community_School

   13.8 to 1 (2021) [2] Color(s) ... South High Community School (SHCS) is a high school located in Worcester, Massachusetts, United States. Demographics.

3. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.

4. List of DIN standards - Wikipedia

   en.wikipedia.org/wiki/List_of_DIN_standards

   Two-part connection for printed boards; grid 2.54mm; dimensions of types Q, R and S: Withdrawn: DIN EN 60603-2: EN 60603-2: DIN 41612-7: Two-part connectors for printed boards; grid 2,54 mm; dimensions of types U and V: Withdrawn: DIN EN 60603-2: EN 60603-2: DIN 41612-8: Two-part connectors for printed boards; grid 2.54 mm; dimensions of type M ...

5. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than ⁠ 1 / 4 ⁠ inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.

6. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   In Japan, the male sizes are often designated as DTC-20, DTC-27, DTC-40 (discontinued) and DTC-45 corresponding to a respective screw head size of 3.2 mm, 4.6 mm, 6.4 mm and 7.7 mm; with the size of the screw measured across the widest portion of the mating part of the head. The most common sizes in use for consumer electronics are DTC-20 and ...

7. Engineering drawing abbreviations and symbols - Wikipedia

   en.wikipedia.org/wiki/Engineering_drawing...

   1. Center line, the central axis of a feature. 2. Class, for example, "paint per spec XYZ revision C type 1 class 2" may be abbreviated as "paint per spec XYZ REV C TY 1 CL 2" or even in some cases "paint per spec XYZ-C-1-2". (The latter practice is not uncommon but is cryptic for workers with minimal training and experience. The first two ...