Search results
Results from the WOW.Com Content Network
Charge carrier density, also known as carrier concentration, denotes the number of charge carriers per volume. In SI units, it is measured in m −3. As with any density, in principle it can depend on position. However, usually carrier concentration is given as a single number, and represents the average carrier density over the whole material.
State of charge (SoC) quantifies the remaining capacity available in a battery at a given time and in relation to a given state of ageing. [1] It is usually expressed as percentage (0% = empty; 100% = full). An alternative form of the same measure is the depth of discharge , calculated as 1 − SoC (100% = empty; 0% = full).
The charge control consists of a pressure switch built into the cell, which disconnects the charging current when the internal cell pressure rises above a certain limit; usually 200 pounds per square inch (1.4 MPa) to 300 pounds per square inch (2.1 MPa). This prevents overcharging and damage to the cell.
The individual cells in a battery pack naturally have somewhat different capacities, and so, over the course of charge and discharge cycles, may be at a different state of charge (SOC). Variations in capacity are due to manufacturing variances, assembly variances (e.g., cells from one production run mixed with others), cell aging, impurities ...
As a result of this current, the battery absorbs a charge and its voltage rises. The charger limits the maximum voltage to U max, a constant or temperature-dependent maximum, typically around 2.4 V per cell. Once the U max voltage is reached, typically when the battery is charged to 70–80% of its capacity, [1] the charger enters the Uo-phase ...
Introduced 1898 as the first flashlight battery. Can be replaced with an AA cell or a C cell using a plastic sabot (size adaptor), with proportional loss of capacity. F: R25 (carbon‑zinc) LR25 (alkaline) 60: 10,500 (carbon‑zinc) 26,000 (alkaline) 1.5: 33 × 91 Four F cells are often found within 6-volt rectangular lantern batteries. N: Lady ...
While the state of charge is usually expressed using percentage points (0 % = empty; 100 % = full), depth of discharge is either expressed using units of Ah (e.g. for a 50 Ah battery, 0 Ah is full and 50 Ah is empty) or percentage points (100 % is empty and 0 % is full). The capacity of a battery may also be higher than its nominal rating.
An AA-sized alkaline battery might have an effective capacity of 3000 mAh at low drain, but at a load of 1 ampere, which is common for digital cameras, the capacity could be as little as 700 mAh. [12] The voltage of the battery declines steadily during use, so the total usable capacity depends on the cutoff voltage of the application.