Search results
Results from the WOW.Com Content Network
Various resistor types of different shapes and sizes. A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. In electronic circuits, resistors are used to reduce current flow, adjust signal levels, to divide voltages, bias active elements, and terminate transmission lines, among other uses.
Also called chordal or DC resistance This corresponds to the usual definition of resistance; the voltage divided by the current R s t a t i c = V I. {\displaystyle R_{\mathrm {static} }={V \over I}.} It is the slope of the line (chord) from the origin through the point on the curve. Static resistance determines the power dissipation in an electrical component. Points on the current–voltage ...
A resistance decade box or resistor substitution box is a unit containing resistors of many values, with one or more mechanical switches which allow any one of various discrete resistances offered by the box to be dialed in. Usually the resistance is accurate to high precision, ranging from laboratory/calibration grade accuracy of 20 parts per ...
One of the functions of many types of multimeters is the measurement of resistance in ohms.. The ohm is defined as an electrical resistance between two points of a conductor when a constant potential difference of one volt (V), applied to these points, produces in the conductor a current of one ampere (A), the conductor not being the seat of any electromotive force.
In schematic diagrams, a resistor is shown as a long rectangle or zig-zag symbol. An element (resistor or conductor) that behaves according to Ohm's law over some operating range is referred to as an ohmic device (or an ohmic resistor ) because Ohm's law and a single value for the resistance suffice to describe the behavior of the device over ...
Two decades of E12 values, which would give resistor values of 1 Ω to 82 Ω The E series is a system of preferred numbers (also called preferred values) derived for use in electronic components . It consists of the E3 , E6 , E12 , E24 , E48 , E96 and E192 series, [ 1 ] where the number after the 'E' designates the quantity of logarithmic value ...
The siemens (symbol: S) is the unit of electric conductance, electric susceptance, and electric admittance in the International System of Units (SI). Conductance, susceptance, and admittance are the reciprocals of resistance, reactance, and impedance respectively; hence one siemens is equal to the reciprocal of one ohm (Ω −1) and is also referred to as the mho.
Resistor based on the sheet resistance of carbon film. Sheet resistance is the resistance of a square piece of a thin material with contacts made to two opposite sides of the square. [1] It is usually a measurement of electrical resistance of thin films that are uniform in thickness.