Ads
related to: billet push-rod suspension conversion
Search results
Results from the WOW.Com Content Network
As such, push-rod suspension systems allow for much greater high-speed stability, much lower levels of body-roll, and a much lower centre of gravity for the vehicle. [7] For pull-rod suspension systems, the only difference is the orientation of the rocker arms. In a push-rod system, the rocker arms are placed at the highest point in the assembly.
The combination of the panhard rod and the torque tube allows the easy implementation of soft coil springs in the rear to give good ride quality, as in Buicks after 1937. Before 1937, Buicks used leaf springs, so the panhard rod was not used, though the torque tube allowed a cantilever spring suspension, which gives a softer ride than a center ...
The opposite arrangement, a "pull rod", will pull on the rod during bump travel, and the rod must be attached to the top of the upright, angled downward. Locating the spring and damper inboard increases the total mass of the suspension, but reduces the unsprung mass, and also allows the designer to make the suspension more aerodynamic.
The MacPherson strut is a common form of strut suspension. This was not the first attempt at strut suspension, but in MacPherson's original patent, the anti-roll bar forms an integral and essential part of the suspension, in addition to its usual function in controlling body roll. A strut suspension like MacPherson's requires a hinged lower ...
Much simpler though, the Goggomobil had bare drive shafts that also acted as the suspension links, with suspension forces passing through the inboard Hooke joints. The swing axle shafts were only carried by the trailing radius rods, rather than an axle casing, and the long struts were shortened to a simple coilover shock absorber.
A Panhard rod (also called Panhard bar, track bar, or track rod) is a suspension link that provides lateral location of the axle. [1] Originally invented by the Panhard automobile company of France in the early twentieth century, this device has been widely used ever since.
The twist-beam rear suspension (also torsion-beam axle, deformable torsion beam, or compound crank) is a type of automobile suspension based on a large H- or C-shaped member. The front of the H attaches to the body via rubber bushings , and the rear of the H carries each stub-axle assembly, on each side of the car.
A torsion bar suspension, also known as a torsion spring suspension, is any vehicle suspension that uses a torsion bar as its main weight-bearing spring. One end of a long metal bar is attached firmly to the vehicle chassis; the opposite end terminates in a lever, the torsion key, mounted perpendicular to the bar, that is attached to a ...
Ads
related to: billet push-rod suspension conversion