Search results
Results from the WOW.Com Content Network
In-line vent for under-cabinet waste plumbing. In-line vent (also known as an island fixture vent, and, colloquially, a "Chicago Loop", "Boston loop" or "Bow Vent") is an alternate method permissible in some jurisdictions of venting the trap installed on an under counter island sink or other similar applications where a conventional vertical ...
According to the International Residential Code 2003, an air gap length must meet the requirements of being two times the effective inner diameter of the pipe (2×D) in order to be sufficient. [2] A standard widely use in the United States is: A112.1.2 Air Gaps in Plumbing Systems (For Plumbing Fixtures and Water-Connected Receptors)
A plumbing drawing, a type of technical drawing, shows the system of piping for fresh water going into the building and waste going out, both solid and liquid. It also includes fuel gas drawings. Mainly plumbing drawing consist of water supply system drawings, drainage system drawings, irrigation system drawings, storm water system drawings.
In the United States, plumbing codes usually provide strict limitations on how far a trap may be located from the nearest vent stack. When a vent cannot be provided, an air admittance valve may be used instead. These devices avoid negative pressure in the drain pipe by venting room air into the drain pipe (behind the trap).
The IPC is the most widely used plumbing code in the United States and is also used as the basis for the plumbing code of several other countries [citation needed].Wide adoptions are important as they help reduce manufacturer and end-user costs by allowing the use of materials across a wide user base, thus allowing economies of scale in the production of materials used in construction.
The code has been widely used over the past five decades by jurisdictions throughout the United States and internationally. With the publication of the 2003 Edition of the Uniform Plumbing Code, another significant milestone was reached. For the first time in the history of the United States, a plumbing code was developed through a true ...
This code is also used as the basis for the plumbing codes of some other countries. Another model plumbing code published and utilized widely across the United States is the Uniform Plumbing Code , published by the International Association of Plumbing and Mechanical Officials ( IAPMO ), a multinational operation with offices in 13 nations.
Any material permitted by the plumbing, health, or building code (as applicable) may be used, but it must be compatible with the other materials in the system, the fluids being transported, and the temperature and pressure inside (and outside) the system. Brass or bronze fittings are common in copper piping and plumbing systems.