Search results
Results from the WOW.Com Content Network
The amount of stretch or compression along material line elements or fibers is the normal strain, and the amount of distortion associated with the sliding of plane layers over each other is the shear strain, within a deforming body. [2] This could be applied by elongation, shortening, or volume changes, or angular distortion. [3]
In geology, the term compression refers to a set of stresses directed toward the center of a rock mass. Compressive strength refers to the maximum amount of compressive stress that can be applied to a material before failure occurs.
In geology, the term "tension" refers to a stress which stretches rocks in two opposite directions. The rocks become longer in a lateral direction and thinner in a vertical direction. One important result of tensile stress is jointing in rocks.
When an object is subjected to a force in a single direction (referred to as a uniaxial compression), the compressive stress is determined by dividing the applied force by the cross-sectional area of the object. [1] Consequently, compressive stress is expressed in units of force per unit area. Axial Stress
In mechanics, compressive strength (or compression strength) is the capacity of a material or structure to withstand loads tending to reduce size (compression). It is opposed to tensile strength which withstands loads tending to elongate, resisting tension (being pulled apart).
We now consider an incompressible material under uniaxial tension, with the stretch ratio given as =, where is the stretched length and is the original unstretched length. The pressure p {\displaystyle p} is determined from incompressibility and boundary condition σ 2 = σ 3 = 0 {\displaystyle \sigma _{2}=\sigma _{3}=0} , yielding:
In areas of high crustal stretching, individual extensional faults may become rotated to too low a dip to remain active and a new set of faults may be generated. [3] Large displacements may juxtapose syntectonic sediments against metamorphic rocks of the mid to lower crust and such structures are called detachment faults.
The rate of axial deformation is kept constant, i.e., strain is controlled. The test allows the sample and the pore pressures to fully consolidate (i.e., adjust) to the surrounding stresses. The test may take a long time to allow the sample to adjust, in particular low permeability samples need a long time to drain and adjust strain to stress ...