enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Keystone module - Wikipedia

   en.wikipedia.org/wiki/Keystone_module

   A keystone module for a CAT5 network cable A 3-port keystone wall plate. A keystone module is a standardized snap-in package for mounting a variety of low-voltage electrical jacks or optical connectors into a keystone wall plate, face plate, surface-mount box, or a patch panel.

3. Cable entry system - Wikipedia

   en.wikipedia.org/wiki/Cable_Entry_System

   For routing of standard cables and other electrical, pneumatic or hydraulic lines through machine, panel or enclosure walls, cable glands, self-sealing grommets or gland plates can be used to seal the cut-outs required for passing the cables through. This protects the inside of an enclosure or machine from dirt, dust or liquids.

4. Keystone wall plate - Wikipedia

   en.wikipedia.org/wiki/Keystone_wall_plate

   Keystone wall plates are made to work with many different types of cabling solutions, including coaxial, twisted pair, HDMI, optical fiber, etc. Keystone wall plates are made of plastic and have one to twelve ports. A keystone port is a hole in the wall plate which allows the insertion of a keystone module or other male or female cabling ...

5. Dehumidifier - Wikipedia

   en.wikipedia.org/wiki/Dehumidifier

   Dehumidifiers are designed to pass air directly over the cooling coils and then the heating coils in a single efficient pass through the device. In addition, most air conditioners are controlled by a thermostat which senses temperature, rather than a humidistat that senses humidity and is typically used to control a dehumidifier.

6. Cable gland - Wikipedia

   en.wikipedia.org/wiki/Cable_gland

   Thus, pre-assembled cables can be routed without removing the plugs. Split cable glands can reach an ingress protection of up to IP66/IP68 and NEMA 4X. Alternatively, split cable entry systems can be used (normally consisting of a hard frame and several sealing grommets) to route a large number of pre-terminated cables through one wall cut-out.

7. IEEE 802.3 - Wikipedia

   en.wikipedia.org/wiki/IEEE_802.3

   IEEE 802.3 is a working group and a collection of standards defining the physical layer and data link layer's media access control (MAC) of wired Ethernet.The standards are produced by the working group of the Institute of Electrical and Electronics Engineers (IEEE).

8. Network isolator - Wikipedia

   en.wikipedia.org/wiki/Network_isolator

   Such voltage differences can also arise through incorrect installation and wiring of network systems, electrical shorting within damaged cables and cabling, or shorting between damaged network cables and other voltage sources. Network isolators work to remove this hazard, by electrically disconnecting medical devices from a network.

9. Ethernet crossover cable - Wikipedia

   en.wikipedia.org/wiki/Ethernet_crossover_cable

   A crossover cable may also be used to connect two hubs or two switches on their upstream ports. Because the only difference between the T568A and T568B pin and pair assignments are that pairs 2 and 3 are swapped, a crossover cable may be envisioned as a cable with one modular connector following T568A and the other T568B (see TIA/EIA-568 wiring ...