Search results
Results from the WOW.Com Content Network
Whether you're buying a new or used car, selling your car, repairing or maintaining your current car, our articles and tools will give you the confidence to tackle any situation.
The motion ratio of a mechanism is the ratio of the displacement of the point of interest to that of another point.. The most common example is in a vehicle's suspension, where it is used to describe the displacement and forces in the springs and shock absorbers.
They show an almost linear increase in lift coefficient with increasing angle of attack with a gradient known as the lift slope. For a thin airfoil of any shape the lift slope is π 2 /90 ≃ 0.11 per degree. At higher angles a maximum point is reached, after which the lift coefficient reduces.
In fluid dynamics, total dynamic head (TDH) is the work to be done by a pump, per unit weight, per unit volume of fluid.TDH is the total amount of system pressure, measured in feet, where water can flow through a system before gravity takes over, and is essential for pump specification.
Car hydraulics are equipment installed in an automobile that allows for a dynamic adjustment in height of the vehicle. These suspension modifications are often placed in a lowrider, i.e., a vehicle modified to lower its ground clearance below that of its original design. With these modifications, the body of the car can be raised by remote control.
Various other characteristics affect the coefficient of drag as well, and are taken into account in these examples. Many sports cars have a surprisingly high drag coefficient, as downforce implies drag, while others are designed to be highly aerodynamic in pursuit of a speed and efficiency, and as a result have much lower drag coefficients.
Comparison between normal and portal axles Pinzgauer portal axle. A portal axle (or portal gear lift) is an off-road vehicle suspension and drive technology where the axle tube or the half-shaft is offset from – usually above – the center of the wheel hub and where driving power is transferred to each wheel via a simple gearbox, built onto each hub. [1]
Power-to-weight ratios for vehicles are usually calculated using curb weight (for cars) or wet weight (for motorcycles), that is, excluding weight of the driver and any cargo. This could be slightly misleading, especially with regard to motorcycles, where the driver might weigh 1/3 to 1/2 as much as the vehicle itself.