Search results
Results from the WOW.Com Content Network
It is important to determine the type of finish of a wood floor and always treat it in the proper manner, for instance it is difficult to clear wood floor wax from a floor coated with polyurethane. Simple cleaning instructions: [8] Clear the floor of any furniture that is easy to move. Sweep or vacuum all loose dirt and debris.
Overpaint and surface coatings can be removed either mechanically or with the use of solvents. Mechanical removal of overpaint include physical techniques to remove the coating from the surface. On a glazed surface a sharp needle or scalpel can be used. If mechanical removal is not possible without damaging the surface, solvents can be used ...
One more helpful tip: Whether you’re trying to remove wax or simply doing some regular cleaning, never use these 13 products on your wood floors. What you’ll need. Ice. Dry towel. Spoon or ...
The bleaches used to remove unwanted fungal stains from wood include two-part peroxide bleach and solutions of sodium hypochlorite. [27] The former is particularly effective at removing the natural colour of wood before it is recoloured with pigmented stains or dyes. [27] Oxalic acid is particularly effective at removing iron stains from wood. [27]
A floor scrubber. A floor scrubber is a floor cleaning device. It can be a simple tool such as a floor mop or floor brush, or in the form of a walk-behind or a ride-on machine to clean larger areas by injecting water with cleaning solution, scrubbing, and lifting the residue off the floor.
Wax emulsions based on beeswax, carnauba wax and paraffin wax are used in creams and ointments. The emergence of soybean waxes with varying properties and melt points has led to the use of vegetable wax emulsions in applications such as paper coatings, paint and ink additives, and even wet sizing for pulp and paper applications.
Detached flakes of coating are removed by brushing with a soft brush. Pressure-sensitive tape is applied over the crosshatch cut. Tape is smoothed into place using a pencil eraser over the area of the incisions. Tape is removed by pulling it off rapidly back over itself as close to an angle of 180°. Adhesion is assessed on a 0 to 5 scale.
The result of this "gecko tape" was tested by attaching a sample to the hand of a 15 cm high plastic Spider-Man figure weighing 40 g, which enabled it to stick to a glass ceiling, as is shown in the figure. The tape, which had a contact area of around 0.5 cm 2 with the glass, was able to carry a load of more than 100 g. However, the adhesion ...