Search results
Results from the WOW.Com Content Network
Evaporation is a common method of thin-film deposition. The source material is evaporated in a vacuum. The vacuum allows vapor particles to travel directly to the target object (substrate), where they condense back to a solid state. Evaporation is used in microfabrication, and to make macro-scale products such as metallized plastic film.
Evaporative deposition: the material to be deposited is heated to a high vapor pressure by electrical resistance heating in "high" vacuum. [4] [5] Close-space sublimation, the material, and substrate are placed close to one another and radiatively heated. Pulsed laser deposition: a high-power laser ablates material from the target into a vapor.
Demonstration of evaporative cooling. When the sensor is dipped in ethanol and then taken out to evaporate, the instrument shows progressively lower temperature as the ethanol evaporates. Rain evaporating after falling on hot pavement. Evaporation is a type of vaporization that occurs on the surface of a liquid as it changes into the gas phase. [1]
The PVD process can be carried out at lower deposition temperatures and without corrosive products, but deposition rates are typically lower. Electron-beam physical vapor deposition, however, yields a high deposition rate from 0.1 to 100 μm/min at relatively low substrate temperatures, with very high material utilization efficiency. The ...
Although the process can be applied to any type of liquid at any vapor pressure, it is generally used to describe the boiling of water by lowering the container's internal pressure below standard atmospheric pressure and causing the water to boil at room temperature. [1] The vacuum evaporation treatment process consists of reducing the interior ...
In technical terms, the dew point is the temperature at which the water vapor in a sample of air at constant barometric pressure condenses into liquid water at the same rate at which it evaporates. [7] At temperatures below the dew point, the rate of condensation will be greater than that of evaporation, forming more liquid water.
Temperatures between 600 and 650 °C and pressures between 25 and 150 Pa yield a growth rate between 10 and 20 nm per minute. An alternative process uses a hydrogen-based solution. The hydrogen reduces the growth rate, but the temperature is raised to 850 or even 1050 °C to compensate.
For deposition to occur, thermal energy must be removed from a gas. When the air becomes cold enough, water vapour in the air surrounding a leaf loses enough thermal energy to change into a solid. Even though the air temperature may be below the dew point, the water vapour in the air alone may not condense spontaneously. This supercooled water ...